• You can log in to your eeworld account to continue watching:
  • Transistor Resonant Amplifier 2
  • Login
  • Duration:43 minutes and 51 seconds
  • Date:2019/03/24
  • Uploader:JFET
Introduction
This course mainly studies the working principles and composition of each unit of sending and receiving equipment in communication systems, as well as the working principles, typical circuits and analysis methods of various unit circuits that constitute sending and receiving equipment. It should be noted that in nonlinear electronic circuits, in order to achieve the same function, different circuit forms are used due to different index requirements. In addition, even if the circuit is of the same form, if its working status, input signal properties, level, output filter characteristics, etc. are different, the functions implemented will be different. Therefore, we must pay attention to mastering the basic principles of various functional circuits, the characteristics and applicable occasions of different circuits, and grasping the internal connections and commonalities of each functional circuit.
Unfold ↓

You Might Like

Recommended Posts

HEEEEEEEELP!!! Atmel Studio cannot be installed, and it always says Cannot find one or more components.
I installed Atmel Studio on the E drive before. Recently, my computer had a problem and I reinstalled the system. The AS overwrote the installation. During the installation, it kept saying Cannot find
曾经in Microchip MCU
Easy Power Point Share
chenzhufly Analogue and Mixed Signal
Beginners, calculation of C language delay subroutine
I use PIC16F877A, external 4M crystal oscillator, division ratio is 128 (OPTION=0X0F; //Open RB port weak pull-up, divide the frequency to WDT, division ratio is 128) For reference, the subroutine for
flyfinger Microchip MCU
CircuitPython 7.1.0 released
Changes since 7.0.0Initial port for Raspberry Pi Broadcom-based boards. Preliminary support for asyncio cooperative multitasking. bitmaptools: dithering and alphablend are new./li keypad.Events now in
dcexpert MicroPython Open Source section
msp430g2553+nrf24l01 program
I wrote and modified a program to use msp430g2553 to control nrf24l01. The following is the program of the receiving end. It has been tested and can be used. You can refer to it if you need it. #inclu
hjl240 Microcontroller MCU
How to determine the sample-hold time of msp430ADC?
I have found the formulas for ADC's sample-hold time and conversion time. Sample-hold time = 4×N×ADC12CLK. Conversion time = 13×(ADC12CLK/Fadc12clk). My question now is how to determine the values of
adam136 Microcontroller MCU

Recommended Content

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews


Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号