• You can log in to your eeworld account to continue watching:
  • Angle signal demodulation 1
  • Login
  • Duration:47 minutes and 39 seconds
  • Date:2019/03/24
  • Uploader:JFET
Introduction
This course mainly studies the working principles and composition of each unit of sending and receiving equipment in communication systems, as well as the working principles, typical circuits and analysis methods of various unit circuits that constitute sending and receiving equipment. It should be noted that in nonlinear electronic circuits, in order to achieve the same function, different circuit forms are used due to different index requirements. In addition, even if the circuit is of the same form, if its working status, input signal properties, level, output filter characteristics, etc. are different, the functions implemented will be different. Therefore, we must pay attention to mastering the basic principles of various functional circuits, the characteristics and applicable occasions of different circuits, and grasping the internal connections and commonalities of each functional circuit.
Unfold ↓

You Might Like

Recommended Posts

Linux embedded technology enthusiasts exchange group
Linux embedded technology enthusiasts exchange group 68158867 welcomes all enthusiasts to join! ! ! !
fantery Linux and Android
I have been harassing my friends these days...
I asked several friends: What is your ideal? What is your career orientation? Although these are a bit broad and a bit empty, after thinking about them for a few days, although I haven't figured them
soso Talking
It was revealed online that an interviewer at Bilibili belittled the enrollment of Beijing University of Posts and Telecommunications. The relevant person in charge responded that the statement was untrue.
Author: Yu Mengmeng, China Securities Journal   On April 24, a discussion about an interviewer at Bilibili (Bilibili for short) belittling the campus recruits of Beijing University of Posts and Teleco
eric_wang Talking about work
YUV4:2:2 conversion to 4:2:0
The original video stream captured by CCD is usually YUV 4:2:2, but the encoding usually supports 4:2:0 video source, so format conversion is required. This document is based on the specific implement
kooking DSP and ARM Processors
How to use DMA to read spi flash?
When I was reading the SPI flash W25Q128, I found that the speed was very slow. After testing, it only reached 300KB/S, which was far from the requirement. So I wondered if I could use DMA to read it
stone435 stm32/stm8
stm32
Can I assign GPIO value to GPIO port in stm32 like this? GPIO_Write(GPIOA,0XFFFF); Please advise
forever1314 stm32/stm8

Recommended Content

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews


Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号