• You can log in to your eeworld account to continue watching:
  • Mixer principle and circuit 1
  • Login
  • Duration:30 minutes and 4 seconds
  • Date:2019/03/24
  • Uploader:JFET
Introduction
This course mainly studies the working principles and composition of each unit of sending and receiving equipment in communication systems, as well as the working principles, typical circuits and analysis methods of various unit circuits that constitute sending and receiving equipment. It should be noted that in nonlinear electronic circuits, in order to achieve the same function, different circuit forms are used due to different index requirements. In addition, even if the circuit is of the same form, if its working status, input signal properties, level, output filter characteristics, etc. are different, the functions implemented will be different. Therefore, we must pay attention to mastering the basic principles of various functional circuits, the characteristics and applicable occasions of different circuits, and grasping the internal connections and commonalities of each functional circuit.
Unfold ↓

You Might Like

Recommended Posts

Scattered Noise Figure
In the RF field, there are usually three parameters to describe the noise of a device or system: noise figure NF, noise coefficient F and equivalent noise temperature Te. 1. Definition of Noise Index
gmchen RF/Wirelessly
How to use endpoint 0 to control the transmission of arbitrary data packets
Originally, it was used as an interrupt on CE5. There was no problem with batch transmission. Now I need to use endpoint 0 to control the transmission of data packets. Tests have found that only endpo
天天 Embedded System
Is there any power supply solution with input 90-260V output 3-3.5V current 3A?
Is there any solution that can output 3-3.5V with 3A current when input 90-260V? ~
天在山之外 LED Zone
Verilog serial port problem
module my_232_rx(//inputclk,RxD,rst,//outputRxD_data_b);input clk;// 50MHz master clockinput RxD;// RS232 receive data signalinput rst;output RxD_data_b;//Receive data register, save until the next da
eeleader FPGA/CPLD
kw4 Finally, let's talk about pure software, Zephyr's MCUXpresso strategy
[i=s]This post was last edited by freebsder on 2017-4-4 22:14[/i] [size=3] I have always had friends asking me how to develop with eclipse (and its various modified versions). This question is so huge
freebsder NXP MCU
ADS1115 outputs 65535 or 65534 when input voltage is close to 0 during sampling
When I was writing the ADS1115 program just now, I used hardware simulation and found that it was normal when there was voltage, but if the input voltage was basically 0, the simulated value was 65535
Mid_summer Microcontroller MCU

Recommended Content

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews


Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号