• You can log in to your eeworld account to continue watching:
  • Transistor Resonant Amplifier 1
  • Login
  • Duration:45 minutes and 5 seconds
  • Date:2019/03/24
  • Uploader:JFET
Introduction
This course mainly studies the working principles and composition of each unit of sending and receiving equipment in communication systems, as well as the working principles, typical circuits and analysis methods of various unit circuits that constitute sending and receiving equipment. It should be noted that in nonlinear electronic circuits, in order to achieve the same function, different circuit forms are used due to different index requirements. In addition, even if the circuit is of the same form, if its working status, input signal properties, level, output filter characteristics, etc. are different, the functions implemented will be different. Therefore, we must pay attention to mastering the basic principles of various functional circuits, the characteristics and applicable occasions of different circuits, and grasping the internal connections and commonalities of each functional circuit.
Unfold ↓

You Might Like

Recommended Posts

We are looking for mobile phone driver software engineers with more than half a year of embedded driver work experience (Shanghai)
Work location: Caohejing, Shanghai Job nature: Full-time 1) Bachelor degree or above, major in electronics, communications or computer science. 2) Experience in embedded system driver development for
suweibus Embedded System
Incident wave in low frequency signal
When a low-frequency signal is transmitted over a short line, its reflected power wave is ignored and only the incident power wave is counted. If the terminal is open, where does the incident wave go?
secondlife110 RF/Wirelessly
TI mactimer overflow period 320us
Hello everyone: I am currently developing CC2530, which is bare metal development. I did not use TI's zigbee protocol, but used the chip as a simple RF module. When I was working on the real-time cloc
seanwaye Wireless Connectivity
In which case is the assignment symbol in the while(P3=0xff) statement feasible?
[size=4]Today I wrote a key program, although it can't be simulated. But Keil can run it. I would like to ask everyone to answer. [/size] [size=4]#include #define uchar unsigned char #define uint unsi
chenmoumou MCU
sampling
[i=s]This post was last editedby paulhyde on 2014-9-15 03:30[/i]
奋斗了 Electronics Design Contest
2015, 2017 real exam questions series!
[align=center][/align] [font=Arial][size=4]Exam series. You can have an intuitive understanding of the contest questions by studying the past contest questions:[/size][/font][font=Arial] [/font][align
sigma Electronics Design Contest

Recommended Content

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews


Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号