• You can log in to your eeworld account to continue watching:
  • Working principle of resonant power amplifier 1
  • Login
  • Duration:18 minutes and 23 seconds
  • Date:2019/03/24
  • Uploader:JFET
Introduction
This course mainly studies the working principles and composition of each unit of sending and receiving equipment in communication systems, as well as the working principles, typical circuits and analysis methods of various unit circuits that constitute sending and receiving equipment. It should be noted that in nonlinear electronic circuits, in order to achieve the same function, different circuit forms are used due to different index requirements. In addition, even if the circuit is of the same form, if its working status, input signal properties, level, output filter characteristics, etc. are different, the functions implemented will be different. Therefore, we must pay attention to mastering the basic principles of various functional circuits, the characteristics and applicable occasions of different circuits, and grasping the internal connections and commonalities of each functional circuit.
Unfold ↓

You Might Like

Recommended Posts

How to configure GPIO under low power consumption
In order to achieve low power consumption, how do you configure GPIO? I am using S3C2440A. How do I configure GPIO with external load? My current method is to configure it as input if it is not used.
liu0911 Embedded System
What does pin is stuck at VCC/GND mean? Please help
This is my RTL8019AS reset procedure: send a high level to the reset pin rtl_rst to complete the resetmodule RTL_RESET (sysclk, rst_b, rtl_rst, //rst_done, in_start, rst_led //test ); [color=yellowgre
林泉 FPGA/CPLD
My account was stolen... I'm feeling depressed...
I went online at noon today and found that there were 33 reminders. I was wondering why there were 33 reminders when there were no special activities recently. ... I clicked on them... They were all r
cardin6 Talking
[Ask TI] ADC collected voltage does not match actual voltage
The actual input voltage measured by a voltmeter is around 0.2v, but the value obtained by ADC sampling is between 600-700. Short one line to the analog ground, and the value obtained by ADC sampling
安_然 Microcontroller MCU
Can you recommend a VGA to CVBS chip? ~! ~!
Could you please recommend a VGA to CVBS chip for me? . . . My company needs it urgently. . .
liyangsur Analog electronics
Atmel Car Keyless Entry System Solution
Atmel's certified encryption algorithm provides a security level of up to 1025 entropy. This wireless communication link offers the car user additional personalization features as an added benefit, su
frozenviolet Automotive Electronics

Recommended Content

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews


Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号