• You can log in to your eeworld account to continue watching:
  • Feedback type LC oscillator circuit 1
  • Login
  • Duration:45 minutes and 29 seconds
  • Date:2019/03/24
  • Uploader:JFET
Introduction
This course mainly studies the working principles and composition of each unit of sending and receiving equipment in communication systems, as well as the working principles, typical circuits and analysis methods of various unit circuits that constitute sending and receiving equipment. It should be noted that in nonlinear electronic circuits, in order to achieve the same function, different circuit forms are used due to different index requirements. In addition, even if the circuit is of the same form, if its working status, input signal properties, level, output filter characteristics, etc. are different, the functions implemented will be different. Therefore, we must pay attention to mastering the basic principles of various functional circuits, the characteristics and applicable occasions of different circuits, and grasping the internal connections and commonalities of each functional circuit.
Unfold ↓

You Might Like

Recommended Posts

After can changes from loopback mode to normal mode...
I used the official test. When it was set to return mode, it could run normally. I could receive data on the CAN end using zlg's USBCAN-II. After changing to Normal mode, I could not receive data.I lo
风过尘扬 stm32/stm8
Weak pull-up, open-drain output, push-pull output and Schmitt input of microcontroller IO port
Weak pull-up: A relatively weak pull-up, generally used in communication with peripheral devices, such as the IIC bus, but cannot be used in pull-up applications that require driving capability. When
siuhiong 51mcu
Those who know IBMR40E can read this
My computer has 256GB of RAM. I want to expand it to 1GB. It's too far to go to the computer market to install it. I bought a 512GB and a 256GB memory and planned to install it myself, but I can't fin
zyw_124 Embedded System
Learning Edition Tutorial Lesson 12 IIC Bus
The last lesson, the IIC bus tutorial~
youki12345 Integrated technical exchanges
How to convert force into digital display PCB board
My company is designing a product that converts the test force into a digital display, and then controls the entire circuit with a resistor or capacitor sensing button. After obtaining the data, it ca
chj000 PCB Design
Regarding high voltage transmission, I have a vague question
Every time I take a car on the highway, I can see the high-voltage power transmission towers on both sides of the highway. The transmission lines on the towers are not of the same thickness. The line
小瑞 Security Electronics

Recommended Content

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews


Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号