Training

Location:Training / Hot Applications / Industrial Control / STM32 motor control (Hard Rock Technology) / Stepper motor trapezoidal acceleration and deceleration (section 3)_Trapezoidal acceleration and deceleration algorithm implementation analysis 1

You can log in to your eeworld account to continue watching：
Stepper motor trapezoidal acceleration and deceleration (section 3)_Trapezoidal acceleration and deceleration algorithm implementation analysis 1
Login

Duration：1 hours and 8 minutes and 26 seconds
Date：2020/04/03

Uploader：木犯001号

Introduction

keywords： STM32 Motor BLDC Servo PID

This course is a motor control course based on STM32 taught by Hard Rock Technology, including DC brush motor control, PID closed-loop controller, servo control, stepper motor drive and control, DC brushless motor drive and control, etc.

You Might Like

Recommended Posts

Translation of "Chu Shi Biao": Your uncle Liang, let me tell you a few words: your father was a gangster in the past, but he died halfway; now the territory is divided into three parts, and it seems that we can no longer protect Yi; simonprince Talking

Useful Tips | Use PCB layering and stacking to control EMI radiation: There are many ways to solve the EMI problem. Modern EMI suppression methods include: using EMI suppression coatings, selecting appropriate EMI suppression components and EMI simulation design. This a; charmfaith PCB Design

【OPA388】Experience 2: Measured op amp input offset voltage and input voltage noise: [font=微软雅黑] The highlights of TI's new high-precision zero-drift op amp OPAx388 are its ultra-low input offset voltage, typical 0.25uV, maximum 5uV; ultra-low temperature drift: ±0.005μV/°C; and very; jackfrost Analogue and Mixed Signal

May I ask, [Environmental humidity: 5%～85%], what does the [5%～85%] here refer to?: Bluetooth parameters:1. Working voltage (MAX): 1.8~3.6V. The module cannot work when the voltage is lower than 1.8V.2. Total average power consumption of the module: less than 20uA3. Working temperatu; 一沙一世 stm32/stm8

Is it true that the IO status will not change after the MSP430 is put into sleep mode?: I vaguely remember that after the MSP430 enters low power mode, including shutdown mode, it can still maintain the IO status before entering the interrupt. I looked up the information today, but could; zca123 Microcontroller MCU

MSP430 Simulation & Programming: Whether it is simulation or burning program, MSP430 can generally be done through: JTAG, SBW, BSL interface. 1. JTAG uses boundary scan technology. There is a logic interface inside the 430 for JTAG.; 火辣西米秀 Microcontroller MCU

Recommended Content

Hot VideosMore

Hot ArticlesMore

Circuit

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews

Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函

京公网安备 11010802033920号