• You can log in to your eeworld account to continue watching:
  • Stepper motor closed-loop system (Section 3)_Grating ruler and absolute encoder reading
  • Login
  • Duration:1 hours and 14 minutes and 51 seconds
  • Date:2020/04/03
  • Uploader:木犯001号
Introduction
keywords: STM32 Motor BLDC Servo PID
This course is a motor control course based on STM32 taught by Hard Rock Technology, including DC brush motor control, PID closed-loop controller, servo control, stepper motor drive and control, DC brushless motor drive and control, etc.
Unfold ↓

You Might Like

Recommended Posts

The difference between ISO10536, ISO15693 and ISO14443
The ISO 10536 standard was mainly developed between 1992 and 1995. Due to the high cost of this card and few advantages over contact IC cards, this card has never been sold on the market. The ISO 1444
JasonYoo RF/Wirelessly
[Erha Image Recognition Artificial Intelligence Vision Sensor] 6. Identify motors and control their operation
Erha’s object recognition is very powerful, and any object is a piece of cake in front of him. According to the communication format of [Erha Image Recognition Artificial Intelligence Vision Sensor] 5
annysky2012 Domestic Chip Exchange
[N32L43x Review] DAC various waveform output tests
Generally, DAC output is often used in analog signal control, which can control the output voltage of the op amp. This time we will mainly play with its output noise, sine wave, triangle wave, etc. #i
流行科技 Domestic Chip Exchange
LM5117 current cannot reach 3A
I replaced the 10uh inductor in this picture with 14uh, and the voltage was stable at 5V. The two inductors were in the same situation. The load started to decrease from 10 ohms, and the current chang
electricor Power technology
ST60 millimeter wave water medium data transmission test report——part1
ST60 millimeter wave water medium data transmission test reportDocument NumberTR_ST60_0001KeywordsST60, 60GHz, water medium data transmission, water medium communicationSummaryThis test report records
mars4zhu RF/Wirelessly
The influence of electronic ballast on the performance of fluorescent lamps
Abstract: The basic requirements for the matching of ballasts and fluorescent lamps are proposed, and their shortcomings are pointed out. The influence of electronic ballasts on the operation of fluor
zbz0529 Industrial Control Electronics

Recommended Content

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews


Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号