Training

Location:Training / Hot Applications / Industrial Control / STM32 motor control (Hard Rock Technology) / DC brushed motor (Section 5)_MOS tube driving principle analysis (including bootstrap circuit)

You can log in to your eeworld account to continue watching：
DC brushed motor (Section 5)_MOS tube driving principle analysis (including bootstrap circuit)
Login

Duration：58 minutes and 51 seconds
Date：2020/04/03

Uploader：木犯001号

Introduction

keywords： STM32 Motor BLDC Servo PID

This course is a motor control course based on STM32 taught by Hard Rock Technology, including DC brush motor control, PID closed-loop controller, servo control, stepper motor drive and control, DC brushless motor drive and control, etc.

You Might Like

Recommended Posts

EEWORLD University ---- stm32f407 video tutorial: stm32f407 video tutorial : https://training.eeworld.com.cn/course/4924This course explains STM32, from entry to mastery; 木犯001号 MCU

Nano Design Sign-Off from Design to Production: Nano Design Sign-Off from Design to Production; feifei Test/Measurement

How to use DSP software waiting?: How to use software wait?DSP has a fast instruction cycle, so it is necessary to wait when accessing slow memory or peripherals. Waiting can be divided into hardware waiting and software waiting, and; Aguilera DSP and ARM Processors

Tips for testing the phase and amplitude time curve of mobile phone amplifiers: A given amplifier design can be used in a variety of cell phone applications as long as its nonlinearity can be measured and corrected with the appropriate correction factors.Reusing amplifier designs; JasonYoo RF/Wirelessly

Regarding the timing issues and acquisition issues of AD chip ADS1251: The timing of ADS1251 and the corresponding time of each part are shown in the figure below. Is there anything wrong with the reading code I wrote? double GET_DOUT(void) {unsigned int temp = 0x0000000; Mengmei TI Technology Forum

What is the difference between the address field and the endpoint field (ENDP) in USB?: What is the difference between the address field and the endpoint field (ENDP) in USB? The address field has 7 bits, which means it supports 127 devices, but the endpoint field has only 4 bits, which; debugme Embedded System

Recommended Content

Hot VideosMore

Hot ArticlesMore

Circuit

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews

Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函

京公网安备 11010802033920号