This course is a motor control course based on STM32 taught by Hard Rock Technology, including DC brush motor control, PID closed-loop controller, servo control, stepper motor drive and control, DC brushless motor drive and control, etc.
2011 Hot Word: LinuxIn the past, when I was in school, I would try to go around it, but after work, my first job would push me into it.
So began Linux
This was quite tragic - but now I think it has no
This paper gives a specific method of designing an ISO/IEC15693 card reader using TI's latest RF transceiver chip RI-R6C-001A and a microprocessor. It also introduces the communication protocol of RI-
Hello, teachers! ! XDS510 burner is ready to burn the out file of chip 2407. How to set it up? In CCS3.3, under tools, there is TMS320LF24XX Flsh programmer. C2000 plug-in has been installed. Please h
Job Description: 1. Engage in FPGA development of video-related algorithms ; 2. Complete algorithm fixed-point, RTL writing, and board-level debugging; 3. Write design documents and provide correspond
You always give out development boards to whet everyone's appetite. If you really want to give everyone in the forum a chance to learn, you should produce more LM3S8962 development boards and sell the