Training

Location:Training / Hot Applications / Industrial Control / STM32 motor control (Hard Rock Technology) / Brushless DC motor drive and control (Section 2)_The working principle of BLDC 1

You can log in to your eeworld account to continue watching：
Brushless DC motor drive and control (Section 2)_The working principle of BLDC 1
Login

Duration：1 hours and 5 minutes and 42 seconds
Date：2020/04/03

Uploader：木犯001号

Introduction

keywords： STM32 Motor BLDC Servo PID

This course is a motor control course based on STM32 taught by Hard Rock Technology, including DC brush motor control, PID closed-loop controller, servo control, stepper motor drive and control, DC brushless motor drive and control, etc.

You Might Like

Recommended Posts

Is there any purely digital method to accurately measure the time interval of a signal?: The error range of about ten nanoseconds is crazy. I can think of two methods at present. One is to accurately extend the counting time, and the other is to measure several times, which sacrifices the; liumnqti Test/Measurement

LM324 op amp, why does it output 1.2V when I don't give it any signal?: This is an ultrasonic receiving circuit. When I first measured it, I found that the waves it received were very chaotic and always there. Then I did not give it an ultrasonic signal, but only gave it; 赵怡彬 Analog electronics

【TI Classic】Correctly understand the jitter performance of clock devices: [align=left][font=宋体]Hello, dear friends! [/font]:)[font=宋体]Today, I would like to recommend to you the article [/font][font=宋体] "Correctly Understanding the Jitter Performance of Clock Devices[/color; 德州仪器 Analogue and Mixed Signal

Is there a CH4 concentration sensor? I need information urgently. Please help me.: It would be best if there is MCU program code, circuit diagram, etc. The more complete the better. Thank you :); 781974176 51mcu

Looking for a G2452 SPI mode transmission routine: As the title suggests, hope everyone can help, thank you!!; hj-yk Microcontroller MCU

I recently came into contact with two 3D printer control boards and was a little confused. I would like to ask an expert to give his opinion: I recently came into contact with two 3D printer control boards. I am a little confused about their power supply design. I would like to ask the experts to give their opinions. The 3D printer control; 晓寒 stm32/stm8

Recommended Content

Hot VideosMore

Hot ArticlesMore

Circuit

可能感兴趣器件

完成课时学习+分/次

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews

Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函

京公网安备 11010802033920号