Is it correct to use the following formula to calculate the inductance value for this type of SEPIC using coupled inductors?For other DCDC power topologies, the ripple rate of the inductor is r=VIN*D
1. Selection of pull-up resistor for MCUYou can see that when the resistor R1=10k in the reset circuit, RST is high level, and when R1=50, RST is low level. It is obvious that when R1=10k, it is wrong
Humans are full of wisdom, so we invented devices that can provide us with light. In cities, towns and villages all over the world, people use the lighting equipment they created to illuminate dark pl
[i=s]This post was last edited by dontium on 2017-12-26 11:17[/i] Chinese people don’t lay eggs:){:1_102:} Chinese people should be grateful to our ancestors, to our country, and to the land that gave
[i=s]This post was last edited by Electronic Micro Creative on 2017-8-23 21:04[/i] Microchip's 32-bit microcontroller uses the MIPS architecture. The PIC section in the forum seems to have been relati