Altium selects the schematic device and automatically highlights the corresponding PCB device. How to set it?

sfcsdc

Altium selects the schematic device and automatically highlights the corresponding PCB device. How to set it? [Copy link]

It worked before, but not with the newer version.

How to set it back?

PS: It is not the shortcut key T→S to jump. It is the automatic highlighting.

dcexpert

dcexpert

It supports selecting multiple components at the same time by shfit+left click of the mouse, and the PCB will also change accordingly.

qwqwqw2088

Automatic highlight?

sfcsdc

dcexpert posted on 2020-6-12 16:29 It supports selecting multiple components at the same time through shfit+left click of the mouse, and the PCB will also change accordingly.

Thanks, solved it

omega_may

Interactive design, press shift+Ctrl+X

huazjun9002

sfcsdc posted on 2020-6-12 16:45 Thank you, it’s solved

Hello, how did you solve this? I remember it could be automatically highlighted before, but it stopped working later and I had to use TS

huazjun9002

huazjun9002 posted on 2021-11-16 11:09 Hello, how did you solve this problem? I remember that it could be automatically highlighted before, but it stopped working later and I had to use TS

Got it, it’s ctrl+Shift+x to start interactive mode!