MPLAB® Code Configurator is a plug-in tool with a friendly graphical user interface in MPLAB Design programming. This video introduces this tool and installation steps, and demonstrates a small experiment.
I can't post it, so I'll describe it here orally. The STC11F02E microcontroller (compatible with 51) uses the P1_0 pin for output, followed by a 10K resistor, followed by the base of the transistor 39
[i=s]This post was last edited by hwc5201314 on 2015-10-17 10:39[/i] [size=4]Attention! I am still a student, so I can't offer too high a price! [/size][size=4]At the same time, I have a board[/size][
I have just come into contact with file system filtering. I watched Chu Kuangren's tutorial and gained a lot. Because it only supports FAT file system, I modified it slightly to support NTFS (because
I recently made a boost and current expansion circuit using 34063 (as shown below). The input is 5V/500mA, and I hope to output 9V. The output current should be as large as possible. Please give me so
I wanted to use 2410 in a product, so I bought it to use as a development board. But after I bought the development board, I never made the product.
So the development board has been left there, with
A single event upset is likely to affect most digital electronic circuits. Xilinx takes the SEU issue seriously and designs devices with a focus on reducing susceptibility to these radiation-induced e