Introducing STMicroelectronics' new generation of low-power Bluetooth protocol stack (V3. Usability and customizability features. Starting from introducing the technical background such as the function of the chip, we briefly introduce its software architecture and the working principle of the protocol stack, and further introduce in detail the configuration method of the protocol stack, and the theory and implementation of the static protocol stack. Specific demonstration examples are used to support the previous discussion, including detailed steps such as changing the software based on our standard software development kit to implement the functions of the static protocol stack.
[i=s]This post was last edited by fish001 on 2019-11-13 22:28[/i]The voltage following circuit of an op amp, as shown in Figure 1, uses virtual short and virtual open circuits. It looks simple and cle
[i=s]This post was last edited by paulhyde on 2014-9-15 03:41[/i] In electronic circuits, we often see three different symbols: VCC, VDD and VSS. What are the differences between them? 1. Explanation[
[color=#666666][font=Arial, Helvetica, sans-serif][size=18px]TCXO is a crystal oscillator and a thermistor circuit that compensates for the frequency-temperature characteristics inherent in the crysta
First of all, I would like to express my deepest condolences to the victims of the Sichuan earthquake!!! The development board I used is the Broadcom UP-NETARM2410 S3C2410, and the network card is the
I saw the introduction of 74HC08, which said: static operating current is 2uA, sink current is 1mA, and output current is 25mA. I would like to ask: Which pins are the currents of the above current pa
The hardware uses stm32h72x+usb3300+ata6563+tja1020 andthe software uses qt+usblib. Two canfd and two LIN busesComplete the basic message sending and receiving functions. The host computer is currentl