Training

Location:Training / Circuit Fundamentals / High Frequency Circuit / Linear shifting circuit of spectrum (7)

You can log in to your eeworld account to continue watching：
Linear shifting circuit of spectrum (7)
Login

Duration：21 minutes and 26 seconds
Date：2017/07/11

Uploader：老白菜

Introduction

keywords： Xidian High Frequency Circuit Chen Jian

The content of this course includes non-resonant power amplifiers, resonant power amplifiers, sinusoidal oscillation, analog multipliers, current mode circuits and current mode multipliers, mixers, amplitude modulation and detection, angle modulation and demodulation, and feedback control systems.

You Might Like

Recommended Posts

How to get the window size (height and width) through the window handle in Wince: How to get the window size (height and width) through the window handle in Wince; AthenaQ Talking about work

uCOS-II transplantation on MSP430 2——Detailed process: 1. Create a new IAR project file and save it in the "E:\430uCOSII\OSTest" folder. Create a new folder src to store the source code. As shown in the figure below. Click to see the larger picture 2. Add; fish001 Microcontroller MCU

[Lao Gao recommends] Good resources recommended this week: [align=center][/align][font=微软雅黑][size=4] I have selected some of the better resources downloaded last week, I hope they are useful to everyone: [list] [*][url=https://download.eeworld.com.cn/detail/s; 高进 Download Centre

Some experience on DSP parallel FLASH booting: The DSP used is 5416, with it as the core, a relatively independent subsystem (hardware, software, algorithm) has been made, and it has been basically completed. Now I will report to you the work done; Jacktang DSP and ARM Processors

How to Use Digital Oscilloscope to Assist Embedded Software Development: Your microcontroller circuit board has been soldered and is being powered on for debugging. You find that a chip controlled by the microcontroller SPI bus is not working properly. The power supply vol; NeoScope MCU

Does anyone know how to design the current limiting resistor on the primary side of the thyristor triggered transformer?: I want to add a current limiting resistor R to the primary side of the thyristor triggered transformer as shown in the figure below, but I don't know how to calculate the value of R. Can an expert giv; sunboy25 Motor Drive Control（Motor Control）

Recommended Content

Hot VideosMore

Hot ArticlesMore

Circuit

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews

Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函

京公网安备 11010802033920号