Training

Location:Training / Circuit Fundamentals / High Frequency Circuit / High frequency electronic circuit final review course (3)

You can log in to your eeworld account to continue watching：
High frequency electronic circuit final review course (3)
Login

Duration：20 minutes and 33 seconds
Date：2017/07/11

Uploader：老白菜

Introduction

keywords： Xidian High Frequency Circuit Chen Jian

The content of this course includes non-resonant power amplifiers, resonant power amplifiers, sinusoidal oscillation, analog multipliers, current mode circuits and current mode multipliers, mixers, amplitude modulation and detection, angle modulation and demodulation, and feedback control systems.

You Might Like

Recommended Posts

Is it the inverter or the integrator circuit?: As shown The input Uin of the op amp is obtained from the -380VDC bus through resistor voltage division to obtain -3.5VDC Is the op amp in the figure a simple inverting 1:1 amplifier circuit, or is it; shaorc Analog electronics

How to configure uclinux to automatically obtain an ip after arm is powered on?: How to configure uclinux to let arm automatically get ip after power on? My development board is S3C44B0. I heard that uclinux supports dhcp. 1. What should I choose when compiling uclinux 2.4 kernel; wawj1819 Linux and Android

Can first-tier devices do the job?: Previously, the sensor head was made by Honeywell combined with first-line devices. The SHT21 may be smaller in size. The I2C interface direct cable transmission requires signal preprocessing. Can fir; bjwl_6338 DIY/Open Source Hardware

linux-2.6.34 kernel porting documentation [simple operation]: I just transplanted the kernel image file, put it on the development board and ran it for a while, and the system is running!!! Pictures speak louder than words...See the attached documentation for th; 37°男人 Embedded System

Introduction to the training for the 2013 Electronic Design Competition: [i=s] This post was last edited by paulhyde on 2014-9-15 03:11 [/i] Nanhua University Huang Zhiwei prepares for the 2013 Electronic Design Competition - Introduction to some information on training; 黄智伟 Electronics Design Contest

Please tell me about the assembly instructions related to AVR program jump: I've been working on the assembly of AVR recently and encountered some problems. I'd like to ask enthusiastic netizens to help me figure out what's going on. The development board I have is atmega128a; lr2131 Microchip MCU

Recommended Content

Hot VideosMore

Hot ArticlesMore

Circuit

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews

Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函

京公网安备 11010802033920号