Training

Location:Training / Circuit Fundamentals / High Frequency Circuit / High frequency resonant amplifier (2)

You can log in to your eeworld account to continue watching：
High frequency resonant amplifier (2)
Login

Duration：22 minutes and 53 seconds
Date：2017/07/11

Uploader：老白菜

Introduction

keywords： Xidian High Frequency Circuit Chen Jian

The content of this course includes non-resonant power amplifiers, resonant power amplifiers, sinusoidal oscillation, analog multipliers, current mode circuits and current mode multipliers, mixers, amplitude modulation and detection, angle modulation and demodulation, and feedback control systems.

You Might Like

Recommended Posts

[My relationship with TI] + It’s a long journey, and I’m grateful to have you by my side!: I probably learned about Texas Instruments when I was a freshman. At that time, I would tell my friends that "This Texas is not that Texas!" In the blink of an eye, I am already a senior. I can see th; 通宵敲代码 TI Technology Forum

Read from P1 port of 51 microcontroller!: Why does it say that to read P1 port, P1 must be set to 1 first, otherwise it will be incorrect! I tried without adding the preceding code page and it worked! Why is this? Thank you!; jb2680 Embedded System

Share an MSP430 open hospital call intercom system: [p=30, null, left][color=rgb(17, 17, 17)][font=宋体][font=Verdana]The hospital call intercom system is one of the important equipment to improve the nursing level of the hospital. Its basic function is; Jacktang Microcontroller MCU

Comparison of solutions + second-order low-pass filter solution: [i=s] This post was last edited by lonerzf on 2014-8-17 17:58 [/i] Because I have used Butterworth second-order low-pass filters several times before. This time I will compare my previous solution wit; lonerzf Analogue and Mixed Signal

Convert eight-bit binary number to BCD code: How to convert an eight-bit binary number into a one-byte BCD code?; 轩辕情伤 Embedded System

PCB Problems: I would like to ask you experts a question:Why is the 0805 package pad red? It is placed on the TOP layer, while most of the other pads are on the MULTI layer? Why is this? If you draw a line on the B; 常见泽1 PCB Design

Recommended Content

Hot VideosMore

Hot ArticlesMore

Circuit

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews

Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函

京公网安备 11010802033920号