Training

Location:Training / Circuit Fundamentals / High Frequency Circuit / High frequency resonant amplifier (7)

You can log in to your eeworld account to continue watching：
High frequency resonant amplifier (7)
Login

Duration：26 minutes and 5 seconds
Date：2017/07/11

Uploader：老白菜

Introduction

keywords： Xidian High Frequency Circuit Chen Jian

The content of this course includes non-resonant power amplifiers, resonant power amplifiers, sinusoidal oscillation, analog multipliers, current mode circuits and current mode multipliers, mixers, amplitude modulation and detection, angle modulation and demodulation, and feedback control systems.

You Might Like

Recommended Posts

Guangzhou is looking for LINUX embedded engineers (can invest in technology after working for 3 years): [align=left][font=宋体][size=12.0pt]Position Name:[/size][/font][size=12.0pt] [/size][font=宋体][size=12.0pt]Embedded[/size][/font][size=12.0pt]LINUX[/size][font=宋体][size=12.0pt]Software Engineer[/size][/; davidshenlie Recruitment

How to determine the end of ADC and what impact does the ADC conversion cycle have on accuracy?: 1. My program uses DMA1 for transmission. How do I determine the end of ADC?Should I determine it inthe void DMA1_Channel1_IRQHandler(void){}function?How should I do it?2. What is the impact of ADC co; lingr stm32/stm8

【allegro】The routing between two components is not correct: As shown in the picture:Why can't the line be pushed straight in this place? ? Help, help~~; ohahaha PCB Design

I found a document about A/D noise performance. Please read it (2): [b]Use noise dithering to improve the spurious-free dynamic range of the ADC[/b] Spurious-free dynamic range (SFDR) is the ratio of the RMS signal amplitude to the RMS value of the largest spurious sp; linda_xia Analog electronics

Regarding "Circuit Design Based on Operational Amplifiers and Analog Integrated Circuits", there is a concept of "Pole" that is not clear: [i=s]This post was last edited by sunboy25 on 2020-10-8 23:15[/i]I would like to ask, is the place where I drew the red circle in the picture above correct as described in the book? Why do I feel that; sunboy25 Analog electronics

RISC-V IDE MRS usage notes (Part 3): Improving floating-point calculation efficiency: MRS has built-in CH32V30X series chips. This series of chips supports FPU (floating point unit). If you want to turn it on, you need to enable the corresponding extension, as shown in the figure below; Moiiiiilter MCU

Recommended Content

Hot VideosMore

Hot ArticlesMore

Circuit

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews

Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函

京公网安备 11010802033920号