The CLK_CCO pin is the clock output pin of STM8. If this pin is set to output the master clock Fmaster, the clock output register can be operated as follows
CLK->CCOR=0X19;
Previous article:stm8 I/O port mode configuration
Next article:Problems encountered in programming stm8 based on STVD
- Popular Resources
- Popular amplifiers
Professor at Beihang University, dedicated to promoting microcontrollers and embedded systems for over 20 years.
- LED chemical incompatibility test to see which chemicals LEDs can be used with
- Application of ARM9 hardware coprocessor on WinCE embedded motherboard
- What are the key points for selecting rotor flowmeter?
- LM317 high power charger circuit
- A brief analysis of Embest's application and development of embedded medical devices
- Single-phase RC protection circuit
- stm32 PVD programmable voltage monitor
- Introduction and measurement of edge trigger and level trigger of 51 single chip microcomputer
- Improved design of Linux system software shell protection technology
- What to do if the ABB robot protection device stops
- Allegro MicroSystems Introduces Advanced Magnetic and Inductive Position Sensing Solutions at Electronica 2024
- Car key in the left hand, liveness detection radar in the right hand, UWB is imperative for cars!
- After a decade of rapid development, domestic CIS has entered the market
- Aegis Dagger Battery + Thor EM-i Super Hybrid, Geely New Energy has thrown out two "king bombs"
- A brief discussion on functional safety - fault, error, and failure
- In the smart car 2.0 cycle, these core industry chains are facing major opportunities!
- The United States and Japan are developing new batteries. CATL faces challenges? How should China's new energy battery industry respond?
- Murata launches high-precision 6-axis inertial sensor for automobiles
- Ford patents pre-charge alarm to help save costs and respond to emergencies
- New real-time microcontroller system from Texas Instruments enables smarter processing in automotive and industrial applications
- TI FAQ: Introduction to LED functions and considerations for LED driver design
- e-Network Limited Time Benefit|"e-Select" products are up to 50% off, place an order and get a 100 yuan cashback!
- I'll post a board late at night~ Is there anyone interested?
- DAPLink Upgrade to 0253
- PCB panelization skills
- Microchip Q&A | New MCU Core Independent Peripheral (CIP) Technology Decryption
- Various CCS compilation errors
- CCS project loading and debugging
- How did you electronic design engineers grow up?
- Whenever there is a heavy rainstorm, I face frequent network outages.