Automatically set timer
Source: InternetPublisher:zht24 Keywords: timer power supply potential pulse Updated: 2020/06/11
Shown is an automatically set timer . This is a monostable multivibrator circuit that pulses reliably when powered on
. Once the power is turned on, capacitor 02 needs a certain amount of charging time, so the potential of pin ② at the trigger input terminal of NE555 can generally be
below 1.3 Vcc, causing NE555 to generate output pulses . Then, because the power supply vcc charges C2 through R2 and VDI, the potential on C2 gradually approaches
vcc, and VD1 is reverse biased to act as an isolation.
- How to build a simple tachometer using an infrared reflectance sensor
- DIY an electromagnetic levitation device
- How to make a wheeled self-balancing robot using ultrasonic sensors
- How to Make a Hot Tub Smart and Remotely Operated with a Raspberry Pi
- A small improvement on the ordinary refrigerator motor starting circuit
- Controlling stepper motors with wireless remote control transceiver and PE-51 board
- Using P110C to control 6 DC motors simultaneously
- Starting method of asynchronous motor with external frequency-sensitive resistor
- Temperature control circuit design and analysis
- Design and analysis of voice control circuit
- Electromagnet control circuit
- Darkroom timed exposure circuit 5
- One of the long delay circuits using integrated circuits
- TDA5142T schematic block diagram and typical applications
- Timer alarm circuit diagram for car or room
- Exposure timer 2
- Precision timer composed of LM567 and MP1826
- Simple and precise timer
- electronic timer
- 9V charger with digital circuit timer