Electromagnet control circuit
Source: InternetPublisher:ghaytweyhtoo Keywords: Control circuit electromagnet BSP switch Updated: 2020/03/24
The principle of using SSR to control and drive AC electromagnets is shown in the figure. Close the switch SW1, and the 220V AC is transformed into 30V AC through the transformer T
, which is rectified by the QL barrier; capacitor C. , G filter, integrated circuit IC7824 voltage stabilization, output +24V supplied to the electromagnet control circuit , and the power
indicator LED1 (red) lights up. This circuit is used for loading electromagnetic cranes used in iron smelting plants and foundries (can lift 0.5t of pig iron at a time). Move
the electric hoist to move the electromagnetic hoist to the raw material (iron) position and lower it to the pig iron pile. Close the switch SW2, the solid state relay SSR1 terminal receives positive power
and is turned on, the SSR pins ③ and ④ are turned on, and the electromagnet DT is energized to attract iron. The electric hoist lifts the electromagnet .
The heated iron raw materials are sent to the iron melting furnace, the switch SW2 is turned off, the pig iron falls into the furnace, and there is a signal light LED2 (green) to indicate when it is working. There is also
an alarm bell DL sound to instruct people to pay attention to safety.
- Audio Adapter Cable - Upgrading Car Audio with MP3 Player
- DIY a practical audio-visual doorbell
- How to design a health emergency alert device using MPU6050
- What components and functions does the battery management system consist of?
- Catillac luggage compartment closing circuit diagram
- EKG FM Demodulator Circuit
- Small improved circuit of hanging electronic watch
- Sensor alarm circuit
- Low cost alarm circuit
- One use and one standby constant pressure water supply frequency conversion speed control circuit b
- stuttering correction circuit
- Bone hyperplasia treatment circuit
- Greenhouse temperature control circuit
- Integrated synchronous detector composed of analog multiplier MC1596
- Diode balanced amplitude modulation circuit
- Crabo oscillator circuit
- Common emitter-common base wideband amplifier circuit composed of F733 integrated amplifier
- Wireless microphone circuit
- Motorcycle flash light circuit
- Various signal generator circuits