• You can log in to your eeworld account to continue watching:
  • share
  • Login
  • Duration:7 minutes and 56 seconds
  • Date:2017/07/21
  • Uploader:老白菜
Introduction
The architecture of the Internet of Things is mainly divided into three layers:
1. Perception layer (Sensors and Sensor networks),
2. Network layer (3G/4G/5G communication network),
3. Application layer (cloud services for various applications).
Perception layer Mainly discusses various wired or wireless sensors (such as temperature, humidity, brightness, gyroscope, three-axis accelerometer, heartbeat, blood pressure, pulse, etc.) and how to construct sensor networks to transmit the data collected by the sensors It is a very challenging task for sensors to achieve low power consumption (high battery life), low cost, small size, long wireless transmission distance, etc. The network layer mainly discusses how to use existing wireless or wired networks to Effectively transmit the collected data, such as using existing 3G/4G wireless transmission technology, or future 5G wireless transmission technology, etc. The application layer mainly explores how various application fields use the results of big data analysis to provide feedback and Control sensors or controller adjustments, etc. Overall, the Internet of Things is a living ecosystem. Sensors collect data and transmit it back to the cloud processing center through mobile phones or other device networks. After analysis, the control information is It is passed back to the controller for various fine or delicate controls.
Unfold ↓

You Might Like

Recommended Posts

Smart Home Power Download
You can take a look at the dedicated power supply for smart home.
gzgtdy DIY/Open Source Hardware
TimerA outputs PWM in continuous mode
[i=s]This post was last edited by woshilee on 2014-4-29 11:47[/i] As shown in the figure, we can see how TA0.1 outputs waveforms, but what about the waveform output by TA0.0? When using output mode 4,
woshilee Microcontroller MCU
【TI Classroom】Problems during login
I had to deal with the registration issue several times before, but this morning with the help of the administrator, I was finally able to enter the main site. But I encountered a new problem: after c
邶风 Microcontroller MCU
Altera asynchronous FIFO operation problem
I have used asynchronous Fifo many times in my current project. The problem is that, in asynchronous mode, I keep writing data to the Fifo and continue writing even when it is full. At the beginning,
yangfpga FPGA/CPLD
Is the reset of the DDR3 chip on the HPS side always low?
I made a board myself, the reset pin of the DDR3 chip on the HPS side is always low, but the DE1 development board does not have any program burned inside, and the pin is high level when powered on. I
hellboy158 FPGA/CPLD
The difference between arm dsp and fpga
[b] The difference between arm, dsp and fpga[/b] Huangyuan Mange 08-05-28 16:36 Published at: [url=http://www.xici.net/b804866/board.asp][color=#0000ff]《EmbeddedWay Embedded System》[/color][/url] Cate
安_然 DSP and ARM Processors

Recommended Content

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews


Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号