NXP develops Class D audio amplifier IC for small speakers

Publisher:rnm888Latest update time:2013-11-05 Keywords:NXP  Class D Reading articles on mobile phones Scan QR code
Read articles on your mobile phone anytime, anywhere

NXP Semiconductors of the Netherlands has started selling the "TFA9887", a Class D audio amplifier IC for small speakers that can increase output power by five times (English release). The company said, "The output power of the previous product was only 0.5W at most, but this IC can achieve an output power of 2.65W (nominal value when the power supply voltage is +3.6V and the load is connected to 4Ω), which is about five times the output power of the previous product." The high output power is achieved by introducing a method to prevent damage to small speakers, specifically, adaptive control, using a current detection amplifier to monitor the small speaker at all times and control the output signal within the safe operating range, which is achieved by integrating a DSP. The new product is mainly targeted at mobile phones, tablet terminals, personal computers, notebook computers, portable game consoles, portable navigation terminals (PNDs) and portable media players.

  The power supply voltage of TFA9887 is +2.5~5.5V. Since a step-up DC-DC converter is integrated, even if the power supply voltage is reduced, it can be increased to the voltage level required to drive the D-class amplifier. The total harmonic distortion + noise (THD+N) is 0.03% (nominal value); the output noise voltage is 45μV (nominal value); the SN ratio is 97dB (nominal value); the power supply ripple rejection ratio (PSRR) is 90dB (nominal value); the audio signal input interface is two I2S interfaces; the supported sampling frequency is 8k~48kHz; the control interface is a 400kHz I2C bus.

  The new product has a volume adjustment function, and is also equipped with overheat protection, overvoltage protection, low voltage protection, overcurrent protection, fraudulent data protection, etc. It uses a 29-terminal WLCSP package with a package area of ​​3.19mm×2.07mm; the operating temperature range is -40~+85℃; samples are now available, but the price is not disclosed.

  

  Class D audio amplifier IC for small speakers that increases output power fivefold

Keywords:NXP  Class D Reference address:NXP develops Class D audio amplifier IC for small speakers

Previous article:Design of single-ended differential audio amplifier with equal signal output
Next article:MAX44260, MAX44261 Low-Power, Rail-to-Rail IO Operational Amplifiers

Recommended ReadingLatest update time:2024-11-16 20:53

Focusing on home medical, NXP brings HPMS semiconductor solutions
The theme of this CMET2010 China International Medical Electronics Technology Conference is portable and home medical electronics. More than 600 professional audiences and engineers attending the conference all came for this theme. As a leader in high-performance mixed-signal semiconductor solutions, Jin Yujie, dire
[Industrial Control]
Focusing on home medical, NXP brings HPMS semiconductor solutions
This article summarizes the four major enabling technologies of mobile robots and NXP solutions!
The mobile space is evolving rapidly with the rapid advancement of robotics and device technologies. They are driving the continued evolution of the mobile robotics ecosystem at multiple levels by integrating new technologies. The following key trends are driving innovations in processing, sensors, and the field
[robot]
Security and anti-theft tips: car lock IMMO/RKE/PKE solutions
Car safety and anti-theft The initial electronicization began with engine immobilizer ( IMMO ) in 1994. NXP was the first semiconductor company to successfully apply RFID electronic tag technology to car electronic engine locks: electronic identity recognition was achieve
[Automotive Electronics]
Security and anti-theft tips: car lock IMMO/RKE/PKE solutions
Datang NXP: Battery management chip innovation leads the transformation of the new energy industry
Liu Huanhuan, senior field application engineer at Datang NXP Semiconductors, recently gave a speech titled "Innovation in Battery Management Chips, Leading the Transformation of the New Energy Industry" at the 2021 International Automotive Electronics Innovation and Development Forum. The following is the content of
[Automotive Electronics]
Datang NXP: Battery management chip innovation leads the transformation of the new energy industry
Elektrobit and NXP collaborate on S32G3 processor to promote the development of software-defined automotive technology
On August 3, Elektrobit announced that its industry-leading software product line can be used to develop automotive electronic control units (ECUs) based on the latest AUTOSAR standard, and its Linux solution also supports NXP® Semiconductors' new S32G3 automotive network processor. The S32G3 family of processors more
[Automotive Electronics]
Elektrobit and NXP collaborate on S32G3 processor to promote the development of software-defined automotive technology
Insight into the radar trends in 2024: Will the long-term integration lead to separation? Talk about NXP's new generation of RFCOMS radar SAF86xx
NXP's software-defined automotive platform will add a new family member in 2024: RFCOMS radar SAF86xx. This radar product was unveiled at the CES exhibition in Las Vegas not long ago. According to the explanations of Zhai Xiaoshu, marketing director of NXP's Greater China Automotive Electronics Division, and Yang Ch
[Automotive Electronics]
Insight into the radar trends in 2024: Will the long-term integration lead to separation? Talk about NXP's new generation of RFCOMS radar SAF86xx
Cortex-M3 (NXP LPC1788) PWM
        PWM is pulse width modulation, which can be used to output a square wave with a certain duty cycle. LPC1788 has two PWMs, each of which can have 6 outputs, PWM1~PWM6. The following describes how to use PWM0.1 to output PWM waves.         1. PWM uses the common PCLK, so the system clock and peripheral clock nee
[Microcontroller]
NXP's Li Tingwei: The changing automotive industry is reshaped by "chips"
The second "I Say IC" industry salon, organized by Zhangjiang Hi-Tech Park and Xinmou Research, was held in Zhangjiang Hi-Tech Park, Pudong New Area, Shanghai. During the salon, Li Tingwei, senior vice president and chairman of Greater China of NXP Semiconductors, delivered a keynote speech entitled "Disruptive Innova
[Embedded]
Latest Analog Electronics Articles
Change More Related Popular Components

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews


Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京ICP证060456号 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号