SetEPTxCount(ENDP2, count)
If count is less than or equal to the COUNT specified in the report description, the USB input device can send data, but the HID Complaint Device cannot obtain data when requesting data from the USB input device layer.
First select:
In BUS Hound:
If count <=report Count Size: then the results are as follows:
On the contrary: when count >report Count Size: as follows:
The above one is that the HID Complaint Device cannot request data from the USB input device, while the following one can request data!
Previous article:STM flash data read
Next article:Research on ARM Bare Metal Program
- Popular Resources
- Popular amplifiers
- Learn ARM development(16)
- Learn ARM development(17)
- Learn ARM development(18)
- Embedded system debugging simulation tool
- A small question that has been bothering me recently has finally been solved~~
- Learn ARM development (1)
- Learn ARM development (2)
- Learn ARM development (4)
- Learn ARM development (6)
Professor at Beihang University, dedicated to promoting microcontrollers and embedded systems for over 20 years.
- LED chemical incompatibility test to see which chemicals LEDs can be used with
- Application of ARM9 hardware coprocessor on WinCE embedded motherboard
- What are the key points for selecting rotor flowmeter?
- LM317 high power charger circuit
- A brief analysis of Embest's application and development of embedded medical devices
- Single-phase RC protection circuit
- stm32 PVD programmable voltage monitor
- Introduction and measurement of edge trigger and level trigger of 51 single chip microcomputer
- Improved design of Linux system software shell protection technology
- What to do if the ABB robot protection device stops
- CGD and Qorvo to jointly revolutionize motor control solutions
- CGD and Qorvo to jointly revolutionize motor control solutions
- Keysight Technologies FieldFox handheld analyzer with VDI spread spectrum module to achieve millimeter wave analysis function
- Infineon's PASCO2V15 XENSIV PAS CO2 5V Sensor Now Available at Mouser for Accurate CO2 Level Measurement
- Advanced gameplay, Harting takes your PCB board connection to a new level!
- Advanced gameplay, Harting takes your PCB board connection to a new level!
- A new chapter in Great Wall Motors R&D: solid-state battery technology leads the future
- Naxin Micro provides full-scenario GaN driver IC solutions
- Interpreting Huawei’s new solid-state battery patent, will it challenge CATL in 2030?
- Are pure electric/plug-in hybrid vehicles going crazy? A Chinese company has launched the world's first -40℃ dischargeable hybrid battery that is not afraid of cold
- [HPM-DIY] HPM SDK updated to 0.13 SD card reading and writing performance greatly improved
- Radio communication equipment manufacturing
- How to learn hardware circuits well
- The difference between grounding and not grounding the input end of the differential amplifier circuit
- FAQ_Huawei smartphones cannot search for BLE devices based on Bluencg-132
- TM4C 129 CAN communication
- How to maintain the performance of industrial control chassis
- Who knows about BMS protection delay?
- Ride: Which country will be the ultimate winner in 5G? Reply to this post and give points
- How to clearly mark chip pins with multiple functions in the schematic library?