|
This is the pin diagram of the simplest STM8S003F3P6 in the STM8S series. Without using an external crystal oscillator, you only need to connect appropriate components to the VCAP and NRST pins to form a minimum system:
Among them, C2 is an essential component.
To make it suitable for learning and debugging, we need a debugging interface:
J1 is a debugging interface that can be connected to STLINK. With it, you can download programs and debug through STLINK.
Previous article:Thinking about single chip microcomputer problems
Next article:About the expansion of external interrupts of single chip microcomputer
- Popular Resources
- Popular amplifiers
- Learn ARM development(16)
- Learn ARM development(17)
- Learn ARM development(18)
- Embedded system debugging simulation tool
- A small question that has been bothering me recently has finally been solved~~
- Learn ARM development (1)
- Learn ARM development (2)
- Learn ARM development (4)
- Learn ARM development (6)
Professor at Beihang University, dedicated to promoting microcontrollers and embedded systems for over 20 years.
- LED chemical incompatibility test to see which chemicals LEDs can be used with
- Application of ARM9 hardware coprocessor on WinCE embedded motherboard
- What are the key points for selecting rotor flowmeter?
- LM317 high power charger circuit
- A brief analysis of Embest's application and development of embedded medical devices
- Single-phase RC protection circuit
- stm32 PVD programmable voltage monitor
- Introduction and measurement of edge trigger and level trigger of 51 single chip microcomputer
- Improved design of Linux system software shell protection technology
- What to do if the ABB robot protection device stops
- ASML predicts that its revenue in 2030 will exceed 457 billion yuan! Gross profit margin 56-60%
- Detailed explanation of intelligent car body perception system
- How to solve the problem that the servo drive is not enabled
- Why does the servo drive not power on?
- What point should I connect to when the servo is turned on?
- How to turn on the internal enable of Panasonic servo drive?
- What is the rigidity setting of Panasonic servo drive?
- How to change the inertia ratio of Panasonic servo drive
- What is the inertia ratio of the servo motor?
- Is it better for the motor to have a large or small moment of inertia?
- The calculation of constant voltage buck inductor is somewhat confusing
- PCB copper plating problem
- Several rules for power supply design of RF circuits
- Why does TI C6000 need cache?
- Switching power supply waveform
- [Raspberry Pi 4B Review] + Real-time status monitoring website test service resource usage
- The latency of cache in arm system refers to
- 【W806 Lianshengde Development Board】Real-time performance
- CC1352R SimpleLink High-Performance Dual-Band Wireless MCU
- Ov7670 image acquisition source program based on TINYM0 LPC1114