Working process of electromagnetic pump circuit
Source: InternetPublisher:笑流年 Keywords: electromagnetic filter motor Updated: 2020/09/05
Working process of electromagnetic pump circuit
When drinking water, operate the water outlet selector switch SA to allow the AC power to pass through the insulation heater and rectifier diode VDO to supply power to the bridge rectifier circuit VDl--VD4. After rectification, it becomes a DC voltage and is smoothed and filtered
by the capacitor cl . The filtered DC voltage is converted
into a stable voltage of 12 V through the voltage stabilizing circuit , and is added to the electromagnetic pump motor . The motor starts, drives the water pump to work, and the hot water flows out automatically.
- What is a 4-pin PWM header? How do 4-pin PWM fans work?
- Design and selection of electric control valve system drive
- Current output characteristics of brushed motor driver chips. How to increase the peak drive current?
- The meaning and importance of circuit protection, common types of circuit protection
- Controlling LEDs with Multithreading via Dual-Core Programming on Raspberry Pi using MicroPython
- DIY an electromagnetic levitation device
- Methods for Eliminating Noise of Brushed DC Motors
- One-way rotation circuit of motor controlled by contactor
- Design and analysis of wire control circuit
- Electric vehicle battery charging protection circuit
- Multi-channel patrol detection control circuit c
- Photocell trigger control circuit
- Digital camera flash control circuit
- Electromagnet control circuit
- AM radio automatic search and trigger circuit
- PLC light source robot hand bubble control circuit
- Neon light control circuit
- Detection and control circuit of electromagnetic stove
- Typical electronic volume control circuit
- Small signal to large current photoelectric control circuit