Digital camera flash control circuit
Source: InternetPublisher:JFET Keywords: Control circuit flash digital camera LED Updated: 2020/05/19
When taking pictures with a digital camera, you need to turn on the flash at night or
when the light is weak. Increasing the number of light-emitting diodes LED
can meet the different requirements of digital cameras for flash brightness and flash
distance. Figure 9-2 is a typical circuit
of a digital camera flash that can provide 300-400mA current .
An AAT3110-4.5 charge pump chip can only provide
a peak current of 200mA (maximum JF - 250mA/
100ms), so two AAT3110-4.5 charge
pump chips need to be connected in parallel to output a peak current of 400mA.
The peak value of an LED is 100mA, so a peak
current of 400mA can drive 4 LEDs . During the flash pause period, the RC discharge
delay circuit
of the flash gate is composed of the diode VD, R, and C ~
- USB powered portable light
- Solar battery and charging circuit
- Electronic massage and acupuncture device circuit
- Motor speed photoelectric control circuit
- Desk lamp dimming soft switch circuit
- WT8089 holiday lights ASIC
- Automotive LED driver circuit diagram using LT3486
- Temperature control alarm circuit
- Bedside lamp controller circuit
- Night target display circuit diagram
- MAX8630Y/ MAX8630Z driving white LED circuit diagram
- Practical circuit diagram of an LED lamp cup
- High battery life LED circuit based on GEC8310
- "clairvoyance" charger circuit diagram
- MEMS strobe driver circuit diagram
- 3W high power LED drive circuit diagram
- LED signal amplification circuit diagram
- Three-phase alternating current detection circuit
- Industrial static elimination circuit
- Light emitting diode (LED) display driver circuit