2281 views|3 replies

6555

Posts

0

Resources
The OP
 

TI Three-Phase Motor Drive BoosterPack Evaluation Module [Copy link]

The BOOSTXL-DRV8305EVM is a 15A three-phase brushless DC drive stage based on the DRV8305 motor gate driver and CSD18540Q5B NexFET power MOSFETs. The module features independent DC bus and phase voltage sensing as well as independent low-side current shunt sensing for sensorless BLDC algorithms. The module provides 3.3V power to the MCU via the LMR16006 0.6A buck converter. The drive stage is fully protected against short circuit, overtemperature, shoot-through, and undervoltage, and is easily configurable via the SPI interface.

4.4V to 45V voltage supply input
Supports 15A continuous current output with a maximum peak of 20A
Provides phase voltage and current feedback for BLDC sensorless control solutions
Ultra-small (2.0 x 2.2 inches) complete brushless DC drive stage
Drive stage is fully protected, including short circuit, over-temperature, shoot-through and under-voltage protection

This module is ideal for evaluation and rapid development of the DRV8305. It works with all compatible XL LaunchPads and provides primary software support for the LAUNCHXL-F28207F, using MotorWare to support the InstaSPIN-FOC sensorless control solution. Software support for the LAUNCHXL-F28069M and InstaSPIN-MOTION will be available in the next revision of MotorWare.

DRV8305N 三相电机驱动 BoosterPack 评估模块.pdf (1.35 MB, downloads: 22)

This post is from Microcontroller MCU

Latest reply

Does the routine program of this board include all the libraries? I used to think that it was too troublesome to obtain Ti's HFI.lib, and it was not open source. I chose stm32.   Details Published on 2020-9-17 17:07
 

2618

Posts

0

Resources
2
 

Good learning

This post is from Microcontroller MCU
 
 

227

Posts

2

Resources
3
 

Does the routine program of this board include all the libraries? I used to think that it was too troublesome to obtain Ti's HFI.lib, and it was not open source. I chose stm32.

This post is from Microcontroller MCU

Comments

The following is the design information, you can also search for relevant information on the official website  Details Published on 2020-9-17 22:00
 
 
 

6555

Posts

0

Resources
4
 
xy598646744 Published on 2020-9-17 17:07 Does this board's routine come with all the libraries? I used to think that Ti's HFI.lib was too troublesome to obtain, and it was not open source. I chose stm32.

The following is the design information, you can also search for relevant information on the official website

slvc626a.zip (3.45 MB, downloads: 11)

This post is from Microcontroller MCU
 
 
 

Guess Your Favourite
Just looking around
Find a datasheet?

EEWorld Datasheet Technical Support

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号
快速回复 返回顶部 Return list