28377S programming error: Please verify target memory and memory map.

gushi123

28377S programming error: Please verify target memory and memory map. [Copy link]

When I use the emulator to program the controlsuit on a 28377S board, I get this error: C28xx_CPU1: File Loader: Verification failed: Values at address 0x000000000000000 do not match Please verify target memory and memory map. C28xx_CPU1: GEL: File: a data verification error occurred, file load failed. Does this mean that the gel settings of 377 do not match the cmd? If so, where do I modify the gel file? Please help me!

elvike

There is no gel file after ccs4. You may have used the wrong map or selected the wrong MCU model.

gushi123

elvike posted on 2018-12-19 12:15 There is no gel file after ccs4. You should use the wrong map or choose the wrong mcu model

The map is the CMD file, right? I used the routine in TI's official CONTROLSUIT. The same routine can be burned into other 377S, but this 377S reports this error. 0x00000000 corresponds to codeSTART in CMD.

elvike

gushi123 posted on 2018-12-19 13:08 Is map a CMD file? I used the routine in TI's official CONTROLSUIT. The same routine can be burned into other 377S, but this 377S ...

There is another cmd file, xxxx_nonBIOS.cmd or something like that. Check if this one is correct.

gushi123

elvike posted on 2018-12-19 14:21 There is another cmd file, xxxx_nonBIOS.cmd or something like that, make sure this one is correct

I added two cmd files in total, one RAM.cmd and one nonBIOS.cmd,

gushi123

This error appears at the very beginning of the program startup, which is codestart at 0x000000 boot. Is the verification error a problem inside the chip?