Due to product requirements, difficult problems have arisen in circuit design. For example: a 12v battery is connected to a DC-DC boost circuit, and the voltage rises to 18v. The output is then connec
The development board I use is TMS320C5535. I want to do convolution operation. The convolution function I wrote takes too long to calculate, so I use the convol1 function in Dsplib instead. Test data
[size=6][backcolor=yellow]As shown in the figure above, there is a 5 after LED1, which means it is connected to page 5[/size][/backcolor][backcolor=yellow][size=6][backcolor=rgb(255, 255, 0)][size=6]A
[i=s]This post was last edited by qwqwqw2088 on 2016-5-19 10:12[/i] Although many converters have tri-state outputs/inputs, these registers are still on-chip; they allow data pin signals to couple int