I built the typical circuit in the datasheet, with a 3.6V input voltage regulator and a 16 ohm load, and the output is only 3.0V. The capacitors used are ceramic chip capacitors. The two 2.2uf are in
[i=s]This post was last edited by x1816 on 2017-2-21 14:39[/i] [font=黑体][size=6][b]Sensor Introduction[/b][/size][/font] [font=微软雅黑][size=3]The color sensor in the kit is BH1745NUC, and its main funct
DG9051/2/3: Low voltage monolithic CMOS analog switches and multiplexers, DG9051 is an 8-way multiplexer, DG9052 is a dual 4-way multiplexer, DG9053 is a 3-way single-pole double-throw (SPDT) switch,
Today I am going to test the IIC interface using an OLED screen. My touch screen is not working yet, so I will use the OLED to test our TP interface first. The wiring is as follows:After that we need