Training

Location:Training / Embedded Development / Embedded operating system / Introduction to linux kernel programming / Kernel Code Kernel Section 3 2

You can log in to your eeworld account to continue watching：
Kernel Code Kernel Section 3 2
Login

Duration：38 minutes and 38 seconds
Date：2020/05/24

Uploader：桂花蒸

Introduction

keywords： Linux drive Memory management File system

The course content is as follows:

AT&T assembly syntax format
protected mode
linux kernel architecture
boot boot program
kernel code kernel
block device driver
character device driver
file system
memory management

You Might Like

Recommended Posts

Does anyone know where to buy Hirose GT43 series connectors?: The design and development requires the use of Hirose GT43 series connectors, but many agents do not have this type. . . Calling for talents here; phebecat Automotive Electronics

Should I use a linear charger or a switching charger?: Reprinted from: deyisupport Linear chargers and switching chargers are widely used in a variety of applications: hearing aids, smart watches, sensor nodes, mobile phones, laptops... the list goes on!; okhxyyo Analogue and Mixed Signal

What is EDS (Electronic Differential Lock): At present, EDS electronic differential locks have been added to many new cars on the market. Here we will talk about this "strange lock" EDS. 　　　　EDS electronic differential lock, the full name in E; frozenviolet Automotive Electronics

DDS Design Based on FPGA: [i=s] This post was last edited by haoshuai on 2018-8-22 18:05 [/i] [align=left][font=宋体] I am learning FPGA-based DDS design recently. I would like to take this opportunity to record the learning pro; haoshuai FPGA/CPLD

Steps to create a register-based STM32 project in Keil5: [i=s]This post was last edited by CokezzZ on 2021-6-2 15:15[/i]Create a new project folder Create a folder named LED to store the project files, and then create two folders in it. The Listing folder i; 可乐zzZ stm32/stm8

What is a Level 2 or Level 3 charger?: Some batteries have communication chips inside. It is recommended to use a Level 2 or Level 3 charger for charging. I am a little confused about this. What is a Level 2 or Level 3 charger? What chargi; jiuc Analogue and Mixed Signal

Recommended Content

Hot VideosMore

Hot ArticlesMore

Circuit

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews

Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函

京公网安备 11010802033920号