logo Training

ST MEMS sensor

Total of 2 lessons ,6 minutes and 13 seconds
Profile

Description

The X-NUCLEO-IDS01A4 is an evaluation board based on the SPIRIT1 RF module SPSGRF-868 expansion of STM32 Nucleo boards.

The SPSGRF-868 module operates in the 868 MHz ISM band and is ETSI certified. Identification of the operating frequency of the X-NUCLEO-IDS01Ax (x=4 or 5) is performed through two resistors (R14 and R15).

It is compatible with the MORPHO and Arduino UNO R3 connector layout. The X-NUCLEO-IDS01A4 interfaces with the STM32 microcontroller via SPI connections and GPIO pins. The user can change some of the GPIOs by mounting or removing the resistors.

Key Features


STM32 Nucleo expansion board based on the SPSGRF-868

SPGRF-868 characteristics: 

868 MHz ETSI-certified module based on low power, low data-rate sub-1 GHz SPIRIT1 transceiver

Integrated Balun (BALF-SPI-01D3)

Chip antenna



Compatible with STM32 Nucleo boards

Equipped with Arduino UNO R3 connectors

Scalable solution; capable of cascading multiple boards for larger systems

Example firmware for point-to-point communication, compatible with STM32Cube firmware

RoHS compliant

You Might Like

Recommended Posts

What is the difference between while and do...while in TMS320F2812 DSP?
In the process of software development based on TMS320F2812 DSP, the following problem was encountered, and the cause has not been found so far. Development environment introduction: CCS2.21 + TMS320F
ygh405 Microcontroller MCU
Mingdeyang FPGA Series Course Phase 1 Chapter 2 FPGA Design Process
[align=left][color=rgb(51, 51, 51)][font="][size=17px]FPGA design process is the process of developing FPGA chips using EDA development software and programming tools. The typical FPGA development pro
guyu_1 FPGA/CPLD
Looking for a pl/m language editor
There is a project that must use pl/m source insight does not support pl/m is there any editor that can support pl/m, can it have syntax highlighting etc. Thanks
xiaozhou Embedded System
Thermal relay tripped
There are 4 thermal relays at the lower end of a frequency converter. When the circuit breaker at the upper end of the frequency converter is closed under no-load conditions, some of the thermal relay
eeleader Industrial Control Electronics
Need your help.
Hello everyone, I am working on a graduation project on an automatic music playing circuit based on hardware (FPGA), but I don’t know how to write the opening report. Please help me. There are several
dangzhiyi FPGA/CPLD
The project needs to be exposed to Renesas chips
I was given a developed board to familiarize myself with and use an oscilloscope to test the IO, but there is no separate IO or interface on the board, but both require the driver of the previous chip
#sudoroot Renesas Electronics MCUs
Recommended Content
Web users are watching Change

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews


Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号