Training

Location:Training / Embedded Development / Embedded operating system / Introduction to linux kernel programming / Block device driver section 1

You can log in to your eeworld account to continue watching：
Block device driver section 1
Login

Duration：39 minutes and 30 seconds
Date：2020/05/24

Uploader：桂花蒸

Introduction

keywords： Linux drive Memory management File system

The course content is as follows:

AT&T assembly syntax format
protected mode
linux kernel architecture
boot boot program
kernel code kernel
block device driver
character device driver
file system
memory management

You Might Like

Recommended Posts

Why does the power pcb still show as running in DEMO status after successful activation?: [i=s]This post was last edited by Fat Peach Baby on 2015-12-17 16:07[/i] As the title says, I would like to ask an expert for advice. According to the installation instructions, the appearance of this; 胖桃宝贝 PCB Design

Working for ten years (Part 3): You can stop working overtime, but don’t expect a raise or promotion: [font=宋体][color=#000000]It took me so long to write (Part 3) because I was too busy recently. But it’s never too late to write a good article, haha. [/color][/font] [font=Times New Roman][color=#00000; 向农 Talking about work

[After-class exercise] LaunchPad after-class exercise 10: Low power mode: LaunchPad After-Class Exercise 10: Low Power Mode1. Introduction MSP430 can work in one active mode ( AM ) and five low power modes (LPM0~LPM4) . Through software settings to control SCG1 , SCG0 , Osc; 常见泽1 Microcontroller MCU

How to set VirtualCopyEx parameters?: In WINCE5.0 and below, you can use VirtualAlloc+VirtualCopy to access hardware. But it doesn't work in WINCE6.0, and an error will be reported when using VirtualCopy! I found that I can use VirtualAll; qiquanwei225017 Embedded System

Sell a set of TI am335x starter kit (trading in progress): [i=s]This post was last edited by yan2513 on 2014-9-5 20:54[/i] Official product of TI: [url=http://www.ti.com.cn/tool/cn/tmdssk3358#3]http://www.ti.com.cn/tool/cn/tmdssk3358#3[/url] It has been gathe; yan2513 Buy&Sell

51FPGA communication.. program can anyone help me annotate it, I don't understand it... follow the post: //MCU program: #include #include#include void outportb(unsigned char port, unsigned char nVal); unsigned char inportb(unsigned char port); unsigned char swap(unsigned char nVal); main() { while(1) { u; ayuaini99 FPGA/CPLD

Recommended Content

Hot VideosMore

Hot ArticlesMore

Circuit

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews

Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函

京公网安备 11010802033920号