Training

Location:Training / Embedded Development / Embedded operating system / Introduction to linux kernel programming / Bootloader (Section 3)

You can log in to your eeworld account to continue watching：
Bootloader (Section 3)
Login

Duration：57 minutes and 32 seconds
Date：2020/05/24

Uploader：桂花蒸

Introduction

keywords： Linux drive Memory management File system

The course content is as follows:

AT&T assembly syntax format
protected mode
linux kernel architecture
boot boot program
kernel code kernel
block device driver
character device driver
file system
memory management

You Might Like

Recommended Posts

TI Cup 2019 National Undergraduate Electronic Design Competition Winners Announcement: The review of the TI Cup 2019 National Undergraduate Electronic Design Competition (hereinafter referred to as the Competition) has been completed, and the national competition winners list (prelimina; 高进 Electronics Design Contest

Asking for advice: Question about TMS320C5509A low power mode: I would like to ask all the experts, how can I reduce the power consumption of C5509A to the level in the chip manual? I would like to ask all the experts to give me some references. It would be bette; 1159926028@qq.c TI Technology Forum

Based on PSOC6 development board simulation I2C solution X-NUCLEO-IKS01A3's STTS751;: [i=s]This post was last edited by DavidZH on 2019-7-27 21:35[/i]I finally had time to study X-NUCLEO-IKS01A3 on the weekend. Let’s start with the simple ones. STTS751 is a digital temperature sensor w; DavidZH MEMS sensors

ALTERA's fpga schematic file is divided into three parts!: ALTERA's fpga schematic file is divided into three parts!; liulong2007 PCB Design

Apply for VICOR DCM DC-DC converter module related evaluation board for free!: DCM DC-DC Converter Modules High power converters supporting all standard industry input voltagesThe DCM ChiP is an isolated, regulated DC-DC converter that operates from an unregulated wide range inp; eric_wang Analog electronics

Editing and modifying orcad multi-part components: orcad 16.3. Enter the edit part state. At this time, the first part is displayed. Click view->next part to display the next part. Find the required part and edit it.; ienglgge PCB Design

Recommended Content

Hot VideosMore

Hot ArticlesMore

Circuit

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews

Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函

京公网安备 11010802033920号