Training

Location:Training / Embedded Development / Embedded operating system / Introduction to linux kernel programming / Character device driver (section 1)

You can log in to your eeworld account to continue watching：
Character device driver (section 1)
Login

Duration：45 minutes and 5 seconds
Date：2020/05/24

Uploader：桂花蒸

Introduction

keywords： Linux drive Memory management File system

The course content is as follows:

AT&T assembly syntax format
protected mode
linux kernel architecture
boot boot program
kernel code kernel
block device driver
character device driver
file system
memory management

You Might Like

Recommended Posts

AT32F437 Play (5) --- Screen refresh frame rate test SPI DMA peripheral: [i=s]This post was last edited by RCSN on 2021-12-25 08:49[/i]In the previous post, Playing with AT32F437 (4) --- Using SPI transmission as an example to explore the internal flash performance , the a; RCSN Domestic Chip Exchange

Can Vivado simulate and view timing diagrams without testbench?: I use Vivado to simulate a large project. I feel it is troublesome to write so many testbench. Is there any simpler way to simulate it?; 刘123 FPGA/CPLD

F28335 controls sensorless brushless DC motor: I would like to ask, the program for controlling the sensorless brushless motor is TI's source program, but the motor vibrates a lot when it rotates. How should I modify the parameters?; 小渣渣110 Microcontroller MCU

The reason for this waveform of the flyback rectifier: After the flyback power supply has been replaced with a transformer, the waveform of the rectifier diode has become composed of a bunch of small wavy waveforms. The following are the pictures of the r; 繁华落尽Yue Analogue and Mixed Signal

Studying the Drive of Electric Motors - 6: Direction of “Torque”: [i=s]This post was last edited by MianQi on 2021-6-16 18:47[/i]Studying the Drive of Electric Motors - 6: Direction of “Torque”; MianQi Motor Drive Control（Motor Control）

[Repost] Analysis of single-point grounding, multi-point grounding, floating grounding and mixed grounding in PCB design: GND is the abbreviation of the ground terminal of the wire. It represents the ground wire or the zero wire. GND (Ground) on the circuit diagram and the circuit board represents the ground wire or the; 皇华Ameya360 Power technology

Recommended Content

Hot VideosMore

Hot ArticlesMore

Circuit

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews

Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函

京公网安备 11010802033920号