• You can log in to your eeworld account to continue watching:
  • Calculation of joint transmission parameters and load characteristics
  • Login
  • Duration:12 minutes and 18 seconds
  • Date:2020/02/13
  • Uploader:JFET
Introduction
keywords: robot
Robot kinematics and dynamic modeling are the key teaching content of this course. Through this course, students can understand and master the basic principles and modeling methods of robots, establish a systematic and complete basic theoretical system, and prepare for subsequent in-depth study of robot intelligent control and other courses. Build the necessary knowledge base. Focusing on the key content of the course, we designed knowledge points including robot kinematics, dynamics, drive system, posture and trajectory control, force control, intelligent control and MATLAB-based simulation, and initially established and formed course knowledge with its own characteristics. Architecture.
Unfold ↓

You Might Like

Recommended Posts

【AT-START-F425 Review】TMR Servo Driver
[Purpose] In order to demonstrate CAN dual-signal communication, AT32F425 is needed as the receiver to drive the servo to work. [Idea] In the previous example, CH582 uses Bluetooth to control the serv
lugl4313820 Domestic Chip Exchange
The air conditioner has been too cold recently. Do you turn on the air conditioner when you work?
The air conditioner has been too cold recently. Do you turn on the air conditioner when you work?
蓝雨夜 Talking
Two PyCon AU 2019 talks
These are two PyCon AU 2019 speeches recommended by netizen Horihttps://2019.pycon-au.org/talks/extending-micropython-using-c-for-good https://2019.pycon-au.org/talks/micropython-gotchasI'll upload th
dcexpert MicroPython Open Source section
MSP430 Flash Emulation Tool
MSP430 Flash Emulation Tool**MSP-FET is compatible with Code Composer Studio v6 and above** MSP-FET is a powerful emulation development tool (often called a debug probe) that helps users quickly start
fish001 Microcontroller MCU
Smart MM32F0270 timer DMA mode output PWM
For controlling stepper motors, the most important control parameters are the number and frequency of pulses. The combination of the two can achieve the required motor acceleration and deceleration cu
火辣西米秀 Domestic Chip Exchange
If the input power may be 12V or 24V, how should the TVS diode be selected?
[i=s] This post was last edited by z45217 on 2018-12-18 13:53 [/i]The power supply is originally fixed at 12V input. Now it needs to be changed to 12V or 24V. What should the transient suppression dio
z45217 Analog electronics

Recommended Content

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews


Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号