• You can log in to your eeworld account to continue watching:
  • Static error (2): static error and input
  • Login
  • Duration:1 minutes and 44 seconds
  • Date:2020/02/02
  • Uploader:JFET
Introduction
Automatic control theory is a core professional basic course in the automation discipline, and is also the theoretical basis for the research and design of complex engineering control systems. This course, also known as classical control theory, includes (1) Introduction to control systems, focusing on feedback principles; (2) Modeling of control systems, focusing on differential equations and mechanism method modeling, Laplace transform, and transfer functions. , frequency response model, data-driven model and the composition and block diagram transformation of typical control systems; (3) Analysis and performance evaluation of control systems, including the time response, structural properties, stability, steady-state accuracy, dynamic performance and timing of dynamic systems. Domain-frequency domain analysis method; (4) Frequency domain design of control system, PID controller and parameter tuning method, lead and lag correction.
Unfold ↓

You Might Like

Recommended Posts

The east-west direction of the compass is reversed
On the Compass and level app I created, I found that the compass needle was pointing to the west when it should be pointing to the east.Below are two pictures showing the difference in direction betwe
liangtom125 ST MEMS Sensor Creative Design Competition
Looking for a serial port assistant that can send commands alternately and supports 2400 baud rate
As the title says, I need help finding a serial port assistant that can send commands alternately and supports 2400 baud rate I have a device that can send commands alternately, but it doesn't support
sint27 MCU
Registration for the first half of 2019 software exam is now open
[i=s]This post was last edited by yilonglucky on 2019-3-12 11:11[/i] The National Computer Technology and Software Professional Technical Qualification (Level) Examination is now open for online regis
yilonglucky Talking about work
MSP430 G2553 Low Power Mode LPMx
In addition to the active mode during normal operation, MSP430 also supports five low-power modes: LPM0, LPM1, LPM2, LPM3, and LPM4, which are set by the CPUOFF, OSCOFF, SCG0, and SCG1 bits in the sta
灞波儿奔 Microcontroller MCU
OP-07 read voltage
As shown in the photo: the higher the DC voltage connected to the ground by the negative pole of the battery, the greater the error of the AD value read by the microcontroller. Please tell me how to e
JACKYJ.88 Analog electronics
How to set individual trace solder mask windows in DXP?
The circuit needs to drive 8 relays. When multiple relays are closed and turned on, the current increases greatly. To ensure the actual effect, while widening the current line, it is hoped that the so
中信华 PCB Design

Recommended Content

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews


Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号