• You can log in to your eeworld account to continue watching:
  • Block diagram and its transformation (1): transfer function block diagram definition and connection method
  • Login
  • Duration:6 minutes and 21 seconds
  • Date:2020/02/02
  • Uploader:JFET
Introduction
Automatic control theory is a core professional basic course in the automation discipline, and is also the theoretical basis for the research and design of complex engineering control systems. This course, also known as classical control theory, includes (1) Introduction to control systems, focusing on feedback principles; (2) Modeling of control systems, focusing on differential equations and mechanism method modeling, Laplace transform, and transfer functions. , frequency response model, data-driven model and the composition and block diagram transformation of typical control systems; (3) Analysis and performance evaluation of control systems, including the time response, structural properties, stability, steady-state accuracy, dynamic performance and timing of dynamic systems. Domain-frequency domain analysis method; (4) Frequency domain design of control system, PID controller and parameter tuning method, lead and lag correction.
Unfold ↓

You Might Like

Recommended Posts

ZTE's 7nm chip mass production still needs time to catch up with high-end chip track
Source: Feixiang.comOn October 11, news that ZTE's self-developed 7-nanometer chip had been commercially available attracted outside attention. According to media reports, ZTE Vice President Li Hui re
eric_wang Domestic Chip Exchange
How to distinguish between active and passive buzzers?
[i=s]This post was last edited by fish001 on 2018-8-28 22:27[/i] [size=4] A small buzzer currently sold on the market is widely used in various electrical equipment, electronic production, and circuit
fish001 Analogue and Mixed Signal
Comparison of Three Synchronous Designs in FPGA
至芯科技FPGA大牛 FPGA/CPLD
Class D Amplifier Design Example
Data introduction: Using switching mode to achieve low-frequency power amplification (i.e. Class D amplification) is to improve efficiency http://www.cndzz.com/user/show/1444.htm
maker Analog electronics
PROTEL99 Ask
After the schematic is completed, a network table is generated, and then a PCB is created and the network table is imported. There is no error when loading the network table, but why do some component
wangjixing2006 PCB Design
Looking for package SOT128-1
Looking for a package library containing SOT128-1
AD小 Download Centre

Recommended Content

Hot VideosMore

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews


Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号