Hello everyone, I am debugging a capacitive touch screen, but I am using hardware I2C. The ARM side is the master and the touch screen side is the slave. However, no matter how I debug it, it doesn't
Is it possible to enter interrupt simulation during 430 simulation? If not, what should I do? For example, I want to observe the change of a certain value in the interrupt?
Module 2: DMA Module DMA (Direct Memory Access): This module is used to store or retrieve data from a specific location in the device. DMA supports data between on-chip memories and between on-chip me
After I used smartRF04EB to download the point-to-point simple data communication program to the sending board and the receiving board respectively, the two development boards can work normally (the r
[i=s]This post was last edited by hehung on 2022-1-19 22:05[/i]The previous post tried to port FreeRTOS to GD32L233C and successfully implemented two LED lighting tasks: https://en.eeworld.com/bbs/thr