MAX837 Power consumption <10μA with logic output micro light sensor

Mechanical switches are devices that turn on and off the current flowing through a conductor. They are used in a variety of common end-market applications, such as consumer electronics (TVs, set-top boxes, etc.), white appliances (washing machines, refrigerators, air conditioners, microwave ovens, etc.), computer peri

      Samsung has released the 64-megapixel ISOCELL Bright GW1 sensor, which is one of the highest-pixel sensors in the mobile phone field and is close to the HDR dynamic range of the human eye. 　　Like the previous GM1, the GW1 sensor uses pixel-merging Tetracell technology and a re-mosaic algorithm. It can take 64-me

1 Introduction to Elevator Control At present, there are two common ways to control elevators. One is to use a microcomputer as a signal control unit to complete the acquisition of elevator signals, the setting of operating status and functions, and the automatic dispatching and collective operation functions o

If the ignition timing is incorrect or there is a faulty component, the engine cylinders will knock. Modern vehicles have knock sensor systems installed on the engine to minimize knock, which can maximize engine life, increase power and improve fuel efficiency. This article will discuss the basics of engine knock an

Central topic: * Introduction to ESP * Introduction to common sensors in ESP * Design of common sensor interfaces in ESP Solution: * Design of yaw rate * Design of integrated module of longitudinal/lateral acceleration sensor * Data transmission with ECU via CAN bus I

On September 6, Sony Semiconductor Solutions announced the launch of the industry's first stacked SPAD depth sensor IMX459 for automotive LiDAR applications using the direct time-of-flight (dToF) method. The product packages tiny 10 μm square single photon avalanche diode (SPAD) pixels and ranging processing circuit

1 Introduction The information collection unit of the armored vehicle status information collection system is usually connected by CAN bus. In some cases, the rotary connector between the upper and lower parts of the vehicle has no connection space, so a wireless communication module is required to provide

The use of vibrating-wire sensors to measure physical quantities is based on the fact that the vibration frequency of the steel string changes with the tension of the steel wire, and the output is a frequency signal, which has strong anti-interference ability, low cable requirements, and is conducive t