Proteus 8 Frofessional v8.9 SP2
I got this from my senior. It was originally intended to be used to make a writing robot, but later he changed it to Arduino UNO.
I couldn't find any information online, so I used a multimeter to simply test the connection of the part without silkscreen.
Connection
RD2/PMD2/RP19 USR_LED
RD3/PMD3/RP20 USB_LED
OSC1/CLKI/RA7 PRG_KEY
RC7/PMA4/RX1/DT1/SDO1/RP18 3.3V
RE0/AN5/PMRD A4988_ENABLE
RE2/AN7/PMCS A4988_MS1
RE1/AN6/PMWR A4988_MS2
OSC2/CLKO/RA6 A4988_MS3
RD6/PMD6/RP23 STEP
RD7/PMD7/RP24 DIR
RC1/T1OSI/UOE/RP12 A4988_ENABLE
RE2/AN7/PMCS A4988_MS1
RE1/AN6/PMWR A4988_MS2
OSC2/CLKO/RA6 A4988_MS3
RD4/PMD4/RP21 STEP
RD5/PMD5/RP22 DIR
RA0/AN0/C1INA/ULPWU/PMA6/RP0 CURRENT_ADJ
Schematic
Physical map
The 5V of miniUSB on the original board only divides a 3.3V voltage to RC7, which is a bit outrageous. I flew a line to supply 1117-3V3 to generate MCU working power.
Previous article:[PIC18 MCU Learning Notes] 1. Program Burning
Next article:Proteus simulation microcontroller: PIC18 microcontroller simulation
- Popular Resources
- Popular amplifiers
- Learn ARM development(16)
- Learn ARM development(17)
- Learn ARM development(18)
- Embedded system debugging simulation tool
- A small question that has been bothering me recently has finally been solved~~
- Learn ARM development (1)
- Learn ARM development (2)
- Learn ARM development (4)
- Learn ARM development (6)
Professor at Beihang University, dedicated to promoting microcontrollers and embedded systems for over 20 years.
- LED chemical incompatibility test to see which chemicals LEDs can be used with
- Application of ARM9 hardware coprocessor on WinCE embedded motherboard
- What are the key points for selecting rotor flowmeter?
- LM317 high power charger circuit
- A brief analysis of Embest's application and development of embedded medical devices
- Single-phase RC protection circuit
- stm32 PVD programmable voltage monitor
- Introduction and measurement of edge trigger and level trigger of 51 single chip microcomputer
- Improved design of Linux system software shell protection technology
- What to do if the ABB robot protection device stops
- CGD and Qorvo to jointly revolutionize motor control solutions
- CGD and Qorvo to jointly revolutionize motor control solutions
- Keysight Technologies FieldFox handheld analyzer with VDI spread spectrum module to achieve millimeter wave analysis function
- Infineon's PASCO2V15 XENSIV PAS CO2 5V Sensor Now Available at Mouser for Accurate CO2 Level Measurement
- Advanced gameplay, Harting takes your PCB board connection to a new level!
- Advanced gameplay, Harting takes your PCB board connection to a new level!
- A new chapter in Great Wall Motors R&D: solid-state battery technology leads the future
- Naxin Micro provides full-scenario GaN driver IC solutions
- Interpreting Huawei’s new solid-state battery patent, will it challenge CATL in 2030?
- Are pure electric/plug-in hybrid vehicles going crazy? A Chinese company has launched the world's first -40℃ dischargeable hybrid battery that is not afraid of cold
- Low Power Wi-Fi: How Application Attributes Affect Energy Consumption
- USB Type-C interface desktop monitor dedicated solution - single interface solution
- How is this switching transformer wound?
- How to delete products on Pingtouge's scenario-based Bluetooth Mesh cloud platform
- F28335 PWM trigger ADC sampling code + comments
- 【TouchGFX Design】Installation and simple experience
- How is the output V0 of this op amp derived?
- How to configure AFE940? Does anyone have the documentation?
- The LCD screen uses the ILI9325 screen controller, and the 32-bit board is STM32F103ZET6. After burning the program, only the background is lit,...
- About Negative Feedback Amplifier Circuit