Manual digital clock based on 51 single chip microcomputer

Specific implementation functions

Functionality:

(1) Use digital tubes to display hours, minutes and seconds in the format of "hours-minutes-seconds";

(2) Use 6 buttons to control hours, minutes and seconds;

(3) Set the seconds reset button to reset the seconds.

Introduction to MCU

The 51 single chip is a low-power, high-performance CMOS 8-bit microcontroller with 8K in-system programmable Flash memory. With a smart 8-bit CPU and in-system programmable Flash on a single chip, the STC89C51 provides a highly flexible and ultra-effective solution for many embedded control application systems. It has the following standard functions: 8k bytes of Flash, 512 bytes of RAM, 32-bit I/O port lines, watchdog timer, built-in 4KB EEPROM, MAX810 reset circuit, three 16-bit timers/counters, a 6-vector 2-level interrupt structure, and a full-duplex serial port. In addition, the STC89X51 can be reduced to 0Hz static logic operation and supports 2 software-selectable power saving modes. In idle mode, the CPU stops working, allowing RAM, timer/counter, serial port, and interrupt to continue working. In power-off protection mode, the RAM content is saved, the oscillator is frozen, and all microcontroller operations stop until the next interrupt or hardware reset. The maximum operating frequency is 35Mhz, and 6T/12T is optional.

Design ideas

Literature research method: collect and organize relevant research materials on the single-chip microcomputer smart bracelet system, read the literature carefully, and prepare for the research;

Investigation and research method: Through investigation, analysis, specific trials and other methods, the current situation, existing problems and solutions of the single-chip smart bracelet system are discovered;

Comparative analysis method: compare the specific principles of different single-chip smart bracelet systems, as well as the differences in the performance of the same type of sensors, and analyze the research status and development prospects of single-chip smart bracelet systems;

Software and hardware design method: Implement specific hardware through software and hardware design, and finally test whether each function meets the requirements.

program

This design uses KEIL5 software to implement program design, as shown in the figure. As the first programming language learned during undergraduate studies, C language is one of the most familiar programming languages. Of course, due to its powerful functions, C language is currently the most widely used and popular programming language in the world. In the design of single-chip microcomputers, C language has gradually completely replaced assembly language, because compared with assembly language, C language compilation, running, debugging is very convenient, and it has high portability, good readability, and is easy to burn and write hardware systems. Therefore, C language is widely used in single-chip microcomputer design. Keil software is compatible with single-chip microcomputer design, can achieve fast debugging, and generate burning files, and is widely used in C language writing and single-chip microcomputer design.

Simulation Implementation

This design uses protues8.7 software to implement simulation design, as shown in the figure.

Protues is also one of the commonly used design software in MCU simulation design. By designing the hardware circuit diagram and writing the driver, the circuit can be debugged without implementing the hardware. In addition, Protues can also realize PCB design, and can also be combined with KEIL in simulation to facilitate program debugging. It supports multiple platforms and is simple and convenient to use.