nRF24L01 wireless module schematic and connection with 5V microcontroller-EEWORLD

Collect

nRF24L01 is a single-chip wireless transceiver chip produced by NORDIC that operates in the 2.4GHz~2.5GHz ISM frequency band.

Two nrf24l01s can form a simple transceiver. One is used as a remote control, and the other is placed on the car as a receiver.

Output power channel selection and protocol settings can be set through the SPI interface. Almost all microcontroller chips can be connected to complete wireless data transmission.

nRF24L01 schematic diagram:

Connection between nRF24L01 and 5V microcontroller (only applicable to high-impedance port):

Keywords：nRF24L01 Reference address：nRF24L01 wireless module schematic and connection with 5V microcontroller

Previous article：51 MCU common IO port simulation IIC (I2C) interface communication program code
Next article：How to read and write CAT24C32 using C51 microcontroller

Recommended ReadingLatest update time:2024-11-15 10:27

stm32 nRF24L01 wireless module (2): Address of the wireless module

Those who have just started to use nRF24L01 may notice that there are two defined addresses in the routine function. const u8 TX_ADDRESS ={0x34,0x43,0x10,0x10,0x01}; //Send address const u8 RX_ADDRESS ={0x34,0x43,0x10,0x10,0x01}; This is very confusing. Why is the address still an array? And a search on the I

[Microcontroller]

stm32 nRF24L01 wireless module (2): Address of the wireless module

NRF24L01 transmission + receiving program passed the test

Main control STC89C52RC crystal oscillator: 11.0592 while(NRF24L01_TxPacket(tmp_buf)!=TX_OK); //If the transmission fails, it will continue to send until the other party receives it successfully. This sentence is mainly used to detect the completion of the transmission signal. You can take this sentence for your

[Microcontroller]

STC12C5A60S2 uses NRF24L01 and stm32 to communicate

/******************************************/ // // The main frequency of this program is 12MHz, and the microcontroller uses STC12C5A60S2 // /******************************************/ #include "STC12C5A60S2.H" #define uchar unsigned char #define uint unsigned int /********** NRF24L01 register operation comman

[Microcontroller]

NRF24l01 Wireless Temperature Sensor (1)

/* The part of transport programm ,used MCU is AT89C52*/ //////////////////////////////////////////////////////////////////////////////////////////////////// #include reg52.h #include intrins.h typedef unsigned char uchar; typedef unsigned char uint; //****************************************define I/O prot***

[Microcontroller]

nRF24L01 AVR Transmit Receive Driver

#include #include #include "12864.h" Zhixinrui Electronic Technology Community: http://www.zhixinrui.com //------------------------------------------------------------------------------ //spi flag #define DDR_SPI DDRB #define DD_ONE 5 #define DD_MISO 6 #define DD_SCK 7 #define

[Microcontroller]

Popular Resources
Popular amplifiers