After the wrong operation, the chip will be locked and cannot be burned, as shown below:
The solution is to use the STM32 ST-LINK Utility tool to unlock the chip:
First connect the device and then do the following to unlock it under the target option, select unselect all and then apply:
Previous article:Stm32 crashes when jumping from IAP to app
Next article:Solution to parsing failure after data is too long after stm32 transplants cJson
- Popular Resources
- Popular amplifiers
- Learn ARM development(16)
- Learn ARM development(17)
- Learn ARM development(18)
- Embedded system debugging simulation tool
- A small question that has been bothering me recently has finally been solved~~
- Learn ARM development (1)
- Learn ARM development (2)
- Learn ARM development (4)
- Learn ARM development (6)
Professor at Beihang University, dedicated to promoting microcontrollers and embedded systems for over 20 years.
- LED chemical incompatibility test to see which chemicals LEDs can be used with
- Application of ARM9 hardware coprocessor on WinCE embedded motherboard
- What are the key points for selecting rotor flowmeter?
- LM317 high power charger circuit
- A brief analysis of Embest's application and development of embedded medical devices
- Single-phase RC protection circuit
- stm32 PVD programmable voltage monitor
- Introduction and measurement of edge trigger and level trigger of 51 single chip microcomputer
- Improved design of Linux system software shell protection technology
- What to do if the ABB robot protection device stops
- Sn-doped CuO nanostructure-based ethanol gas sensor for real-time drunk driving detection in vehicles
- Design considerations for automotive battery wiring harness
- Do you know all the various motors commonly used in automotive electronics?
- What are the functions of the Internet of Vehicles? What are the uses and benefits of the Internet of Vehicles?
- Power Inverter - A critical safety system for electric vehicles
- Analysis of the information security mechanism of AUTOSAR, the automotive embedded software framework
- Brief Analysis of Automotive Ethernet Test Content and Test Methods
- How haptic technology can enhance driving safety
- Let’s talk about the “Three Musketeers” of radar in autonomous driving
- Why software-defined vehicles transform cars from tools into living spaces
- Why does the newly soldered STM32 main control board run about 10 times slower than normal after programming?
- [Discussion] There is no place to make money during the seven days of National Day holiday
- Linux-3.14.52 Compiler Reference Manual v2.0
- ESP32 firmware is divided into two versions: ESP-IDF v3.x/4.x
- Two methods of programming TMS320C6748
- Enabling higher-performance front-end radar to make Vision Zero a reality
- Power supply control principle of three-phase fuel pump used in Mercedes-Benz passenger cars
- Review summary: Free review of Fudan Micro FM33LG0 series, Winsilver chip
- ESP32-S2-Saola-1 calculates pi
- DCDC H-bridge circuit, what is the principle of boost and buck?