Electric contact mercury thermometer constant temperature control circuit 3b
Source: InternetPublisher:闪电杰克 Keywords: Thermostatic control circuit BSP alarm Updated: 2021/02/20
These two circuits are similar. Figure
Ll-45 (a) is equipped with an over-temperature alarm . The setting value of temperature sensor KP2 should be higher than KP. The setting value is 1~2℃ higher.
For example, if 100 eggs are hatched at a time, 500-600W electric heater wire can be used (straightened and evenly installed on
the bottom of the incubator).
Figure 11-45 (b) shows the temperature control circuit of the DF-500 electric incubator with a capacity of 500 eggs. The shape of the incubator box
is 1000mm high, 970mm wide, 680mm deep, and the insulation layer is 30mm thick. A 75-150W soldering iron core is used
as an electric heater. An instrument fan is installed at the air inlet in the box so that fresh air can be continuously sucked in when the fan is running. The soldering iron
core is fixed in front of the fan blades and directly in front of the fan. Place a plate of clean water somewhere to maintain a certain humidity.
- What is a 4-pin PWM header? How do 4-pin PWM fans work?
- How to choose the right level of integration to meet motor design requirements?
- Servo motor pin diagram/working principle/application
- Build a Smart Garage Door Opener Using a Raspberry Pi
- Introduction to the internal structure of the Delta winding motor
- Motor control circuit for starting and running without phase loss
- One-way rotation circuit of motor controlled by contactor
- Home wireless burglar alarm circuit
- Delay switch made with LM431
- "Watchdog" anti-theft alarm circuit
- Agricultural temperature control circuit
- Fish pond oxygenation reminder circuit
- Soil water shortage prompt circuit
- Domestic KD8041 integrated phase locked loop
- Schiller oscillator circuit
- OTL low frequency power amplifier circuit
- Second-order active band-stop filter circuit
- Wireless microphone circuit
- High and low frequency signal generator circuit
- Sawtooth wave generator circuit (1)