Wiring b of PLC input and output terminals
Source: InternetPublisher:张三叔 Keywords: PLC wiring BSP diode Updated: 2020/01/01
Wiring of PLC input and output terminals
When the PLC input terminal or output terminal is connected with inductive components, freewheeling diodes (DC circuit)
or RC circuits (AC circuit) should be connected in parallel at both ends to suppress the overvoltage generated when the circuit is disconnected. The impact on PLC is as shown in the figure.
In the figure, the t resistor R can range from 51 to 12002, and the capacitor C can range from 0.1 to 0, 47yF.
Latest Control Circuits Circuits
- Working principle of one Xipu STR soft starter controlling two motors
- JDB-LQ-TQ/2 motor full voltage starting circuit
- Design and principle analysis of practical electric curtain remote control device
- Design and analysis of wire control circuit
- Design and analysis of touch delay switch circuit composed of CD4011 and CD4001
- Design and production of no-load automatic power-off device for household power supply
- PIC microcontroller controlled remote anti-theft alarm circuit
- Homemade anti-theft watchdog
- Large range laser burglar alarm
- Home thermostat
Popular Circuits
- Self-defense anti-riot circuit
- Chicken supplementary light to increase egg production rate circuit
- Soil water shortage prompt circuit
- DC ammeter
- Mixer built with analog multipliers
- Simple AGC circuit in transistor radio
- collector amplitude modulation circuit
- Series crystal oscillator
- Inductive feedback oscillator circuit
- Sine wave signal generator circuit
京公网安备 11010802033920号