Internal structure of DTL inverter circuit
Source: InternetPublisher:天天都吃好吃的 Keywords: transistor diode Updated: 2021/02/13
Shown is the internal structure of the DTL inverter circuit (M5936P). Diodes are used at the input , transistors are used for signal processing , and
the power supply is +5V. When the input terminal A is high level (digital "I"), the diode VDI is turned off, the transistor VTI is turned on, and the transistor VT2
is turned on and the output is low level (digital "O"). When the input is low level (digital "0"), the diode VD1 is turned on, the transistor VT1 is turned off,
the transistor VT2 is turned off, and the output is high level (digital "1").
- FPGA Features and Architecture
- Capacitance detection circuit configuration, how to deal with low frequency and high frequency noise?
- Advantages and disadvantages of organic semiconductors, the conductive mechanism of organic semiconductors
- Causes of PCB deformation How to prevent circuit board bending and warping
- Important things to know about PCB routing and how to design the right routing for your PCB
- Ceramic filter structure/working principle/characteristics/application
- Make a flameless electronic candle using simple electronics and LEDs
- Homemade 100-base addition and subtraction counting circuit
- NE5532 standard linear preamplifier IC circuit features and application schematics
- Square wave frequency multiplier (SN15844N, SN7400N)
- What is the fantasy world of diodes like?
- AC voltmeter
- Diode Balanced Mixer Circuit
- Proportional frequency discriminator circuit
- FM modulator strong-weak signal switching circuit c
- Improved multivibrator circuit c
- Internal structure of MC1411 series Darlington current driver d
- One of the non-contact proximity switch circuits
- Manual temperature control circuit 5
- Automatic water supply control circuit 2 for simultaneous monitoring of water tower and reservoir
京公网安备 11010802033920号