AD574A Unipolar and Bipolar Input Circuitb
Source: InternetPublisher:难得正经 Keywords: Input circuit AD BSP Updated: 2021/07/17
AD574A is a high-performance 12-bit successive approximation. A/D converter can directly interface with 8-bit or 16-bit microcomputer bus. The analog voltage input
to AD 574A can be either unipolar or bipolar. The unipolar input analog voltage range is 0-1OV or
0-20V; the bipolar input voltage range is ±5v or 20V.
When unipolar input is used, the B IP OFF terminal should be connected to ov. The circuit connection is shown in Figure a. The BIP OFF terminal in the figure
is connected to ground through a 100n resistor, and the zero point can be adjusted through RP1.
For bipolar input, the BIP OFF terminal is connected to the +lov voltage, and the circuit connection is as shown in Figure b. The B IP OFF terminal in the circuit
is connected to the REF and OU terminals with +10V voltage through the 1000 resistor RP2.
- Important things to know about PCB routing and how to design the right routing for your PCB
- Make a flameless electronic candle using simple electronics and LEDs
- How to build a triangle wave generator using an op amp and discrete components
- Structural diagram and function of sliding resistor
- Experimental circuit based on 4040 binary adder counter
- Touch circuit design and analysis
- FL52C4 induction electronic greeter
- A practical automatic electronic welcome circuit
- Frequency divider that converts 50Hz or 60Hz frequency into 1/60 frequency (CD4040)
- How to make a four-level water level indicator with full water alarm function
- Set timing circuit when power is on
- AD524 gain 200 amplifier
- AD524 pin and internal circuit function block diagram
- AD574A Unipolar and Bipolar Input Circuita
- AD converter AD9887 circuit
- AD2S80A typical connection circuit
- Electronic transformer circuit
- AD590 single point temperature control circuit
- AD693 type 4 to 20mA sensor transmitter circuit
- AD7660 negative voltage and positive voltage doubler output circuit diagram